Við tökum við rafmynt — svo myntirnar sem þú átt geta keypt alvöru vélbúnað.Greiddu í rafmynt, eyddu henni í alvöru vélbúnað. Frí, tryggð sending um allan heim fyrir pantanir yfir 399 $. Hlutlausir pappakassar án merkinga, sendir frá Þýskalandi.Frí, tryggð sending yfir 399 $. Gengið þitt er læst í 30 mínútur um leið og greiðsluferlið hefst.Gengið læst í 30 mínútur. Hver vara er innsigluð, raðnúmer hennar yfirfarið, og hún nýtur 24 mánaða ábyrgðar.Innsiglað, með 24 mánaða ábyrgð.

Vaktaðar vörur Skrá inn

NEMIX RAM

NEMIX RAM 96GB (2×48GB) DDR5-5600 CL46 ECC RDIMM Supermicro H14DST-F

SKU CH-CB97-8E348

Registered ECC DDR5 kit delivers 96 GB across two 48 GB modules at 5600 MHz CL46 for Supermicro H14DST-F servers

  • Capacity96GB (2 x 48GB)
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 5600 (PC5 44800)
  • CAS LatencyCL46
  • Voltage1.10V
  • ECCYes
  • 96 GB capacity from two 48 GB modules for high-density server workloads
  • DDR5-5600 speed with CL46 latency delivers rated throughput on supported platforms
  • ECC and registered design corrects single-bit errors and offloads the memory controller
  • 1 V operation matches the platform's voltage requirement for stable operation
  • Verified fitment for Supermicro H14DST-F with 288-pin RDIMM form factor

Exact-match upgrade for Supermicro H14DST-F

This 96GB kit contains two 48GB DDR5-5600 Registered ECC RDIMMs built to the board's exact specifications. The 2Rx8 rank structure, 1.1V operation and CL46 timing match the memory controller's expectations so the full capacity is recognised at rated speed.

Registered ECC advantage over unbuffered memory

Registered architecture buffers address and command signals, letting every slot run fully populated without overloading the controller. ECC corrects single-bit errors on the fly, preventing silent data corruption and unplanned reboots that unbuffered non-ECC modules cannot stop.

DDR5-5600 bandwidth ceiling

The PC5-44800 interface delivers 5600 MT/s, which caps throughput at the module's rated speed even when all channels are filled. Systems needing higher memory bandwidth or lower latency than this standard provides must move to a platform that supports faster DDR5 data rates.

Helstu kostir

  • 96 GB capacity from two 48 GB modules for high-density server workloads
  • DDR5-5600 speed with CL46 latency delivers rated throughput on supported platforms
  • ECC and registered design corrects single-bit errors and offloads the memory controller
  • 1 V operation matches the platform's voltage requirement for stable operation
  • Verified fitment for Supermicro H14DST-F with 288-pin RDIMM form factor

Tæknilýsing

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR44800-4828K2
Capacity96GB (2 x 48GB)
Type288-Pin DDR5 RDIMM
SpeedDDR5 5600 (PC5 44800)
CAS LatencyCL46
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx8
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content96GB 2X48GB DDR5 5600MHz PC5-44800 2Rx8 1.1V 288-PIN ECC RDIMM KIT

Aðrar útgáfur af þessari vöru

5 í viðbót í sama vöruflokki

Sama fjölskylda, mismunandi minni, kælingu eða klukkuhraða — berðu saman áður en þú ákveður þig.

Spurningar um þessa vöru

What slot type and pin count does this kit require on the Supermicro H14DST-F motherboard?

It uses 288-pin DDR5 RDIMM slots, which are the registered DIMM form factor the board expects.

Which DIMM population order should I follow when installing both 48 GB modules?

Check the H14DST-F manual for the approved slot sequence; installing in the wrong order can prevent the system from recognising the full 96 GB capacity.

Do these modules have a heat spreader that could block adjacent slots or airflow?

No heat spreader is fitted, so the low-profile bare modules fit tightly spaced slots without clearance issues.

Einnig í þessum vöruflokki

Fólk bar þetta saman

Sama hilla, sama greiðsluferli — átta myntir og 30 mínútna gengislæsing.