Við tökum við rafmynt — svo myntirnar sem þú átt geta keypt alvöru vélbúnað.Greiddu í rafmynt, eyddu henni í alvöru vélbúnað. Frí, tryggð sending um allan heim fyrir pantanir yfir 399 $. Hlutlausir pappakassar án merkinga, sendir frá Þýskalandi.Frí, tryggð sending yfir 399 $. Gengið þitt er læst í 30 mínútur um leið og greiðsluferlið hefst.Gengið læst í 30 mínútur. Hver vara er innsigluð, raðnúmer hennar yfirfarið, og hún nýtur 24 mánaða ábyrgðar.Innsiglað, með 24 mánaða ábyrgð.

Vaktaðar vörur Skrá inn
Two bare green DDR5 UDIMM sticks, no heat spreader

NEMIX RAM

NEMIX RAM 96GB (2x48GB) DDR5 5600MHz CL46 2Rx8 1.1V 288-Pin UDIMM for ASRock IMB-A1302 IMB-A1700

SKU CH-NFD3-95XMZ

96 GB DDR5 kit with two 48 GB unbuffered UDIMMs at 5600 MHz CL46 for ASRock IMB-A1302 and IMB-A1700

  • Capacity96GB (2 x 48GB)
  • SpeedDDR5 5600 (PC5 44800)
  • ECCNo
  • Buffered/RegisteredUnbuffered
  • ChipsetMajor OEM Samsung, Micron, Hynix
  • Voltage1.10V
  • 96 GB total capacity from two 48 GB modules
  • DDR5 5600 MHz speed rated as PC5-44800
  • CL46 CAS latency at 1.1 V operating voltage
  • 288-pin unbuffered UDIMM fits ASRock IMB-A1302 and IMB-A1700
  • Dual-rank 2Rx8 organisation using major OEM memory chips

96GB DDR5 kit for ASRock industrial boards

This 96GB kit contains two 48GB DDR5 5600MHz UDIMM modules built for ASRock Industrial IMB-A1302 and IMB-A1700 motherboards. Each module runs at 1.1V with CL46 latency and a 2Rx8 organisation. The kit delivers 96GB of non-ECC unbuffered memory in a standard 288-pin form factor.

Who this suits and who it does not

Builders upgrading compatible ASRock industrial micro-ATX systems to 96GB of DDR5 will find the correct speed, voltage and pin layout here. Systems that require ECC error correction or registered modules cannot use this non-ECC unbuffered kit. Boards limited to lower maximum capacity or a different DDR generation are not supported.

Deciding specification — DDR5 5600 288-pin UDIMM

The single specification that determines fit is the DDR5 5600MHz 288-pin UDIMM interface with 1.1V operation. Only motherboards that accept DDR5 UDIMMs at this speed and voltage can use the modules. Verify the board manual for DDR5 UDIMM support before purchasing.

Helstu kostir

  • 96 GB total capacity from two 48 GB modules
  • DDR5 5600 MHz speed rated as PC5-44800
  • CL46 CAS latency at 1.1 V operating voltage
  • 288-pin unbuffered UDIMM fits ASRock IMB-A1302 and IMB-A1700
  • Dual-rank 2Rx8 organisation using major OEM memory chips

Tæknilýsing

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Memory
ModelDDR5 Non-ECC Unbuffered UDIMM Memory
Part NumberMD44800-4828K2
Capacity96GB (2 x 48GB)
SpeedDDR5 5600 (PC5 44800)
ECCNo
Buffered/RegisteredUnbuffered
ChipsetMajor OEM Samsung, Micron, Hynix
Voltage1.10V
Compatible SystemASRock Industrial
CAS LatencyCL46
Heat SpreaderNo
Type288-Pin DDR5 UDIMM
Rank2Rx8
FeaturesDDR5 Non-ECC Unbuffered UDIMM Motherboard Compatible
Package Content96GB (2 x 48GB) DDR5 5600MHz PC5-44800 2Rx8 1.1V 288-PIN Non-ECC UDIMM KIT

Spurningar um þessa vöru

Will the 288-pin DDR5 UDIMM modules fit the IMB-A1302 or IMB-A1700 motherboard slots?

Yes, the kit uses the standard 288-pin DDR5 UDIMM form factor that matches the DIMM slots on both ASRock Industrial Micro-ATX boards.

What is the correct way to seat the two 48 GB modules so the system recognises the full 96 GB capacity?

Align the notch on each module with the slot key, press straight down until the retention clips click on both sides, and populate the slots recommended in the motherboard manual for dual-channel operation.

Does the lack of a heat spreader on these 1.1 V CL46 modules mean I need to add airflow or replace them sooner?

No, DDR5 UDIMMs at 1.1 V run cool enough for standard chassis airflow; no extra cooling or scheduled replacement is required.

Einnig í þessum vöruflokki

Fólk bar þetta saman

Sama hilla, sama greiðsluferli — átta myntir og 30 mínútna gengislæsing.