Við tökum við rafmynt — svo myntirnar sem þú átt geta keypt alvöru vélbúnað.Greiddu í rafmynt, eyddu henni í alvöru vélbúnað. Frí, tryggð sending um allan heim fyrir pantanir yfir 399 $. Hlutlausir pappakassar án merkinga, sendir frá Þýskalandi.Frí, tryggð sending yfir 399 $. Gengið þitt er læst í 30 mínútur um leið og greiðsluferlið hefst.Gengið læst í 30 mínútur. Hver vara er innsigluð, raðnúmer hennar yfirfarið, og hún nýtur 24 mánaða ábyrgðar.Innsiglað, með 24 mánaða ábyrgð.

Vaktaðar vörur Skrá inn
Two green DDR4 UDIMM sticks, no heat spreaders, gold contacts, 288 pins

OWC

OWC 2E6D41R8016P 16GB (2x8GB) DDR4 2666MHz CL19 ECC UDIMM 1.2V 1Rx8 288-pin memory upgrade

SKU CH-GVRP-TYX45

16 GB DDR4-2666 ECC UDIMM kit (2 × 8 GB, CL19, 1.2 V) validated for Synology RackStation RS1619xs+ and RS2818RP+

  • Capacity16GB (2 x 8GB)
  • Type288-Pin DDR4 ECC UDIMM
  • SpeedDDR4 2666 (PC4 21300)
  • CAS LatencyCL19
  • Voltage1.2V
  • ECCYes

Capacity 16GB (2 x 8GB)

  • 16 GB kit (2 × 8 GB) for Synology RS1619xs+ and RS2818RP+
  • DDR4 2666 MHz CL19 ECC unbuffered UDIMM for data integrity
  • JEDEC-standard 1.2 V modules run cool without heat spreaders
  • Backward compatible with 2133 MHz and 2400 MHz systems
  • 288-pin 1Rx8 design installs easily in supported NAS units

Synology RackStation memory kit

This OWC kit delivers 16 GB of DDR4 ECC UDIMM memory in a matched pair of 8 GB modules. It is validated for Synology RackStation RS1619xs+ and RS2818RP+ systems. The modules run at 2666 MHz with CL19 latency at 1.2 V.

Upgrade from lower-capacity or non-ECC DIMMs

The 16 GB dual-channel kit replaces smaller or single-rank modules to raise total system memory. The jump is worth it when workloads such as virtual machines, container hosts or large file caches exceed the existing capacity and trigger swapping.

DDR4 2666 interface limits

The DDR4 2666 interface caps peak bandwidth at the PC4-21300 rate. The kit is backward compatible with 2133 MHz and 2400 MHz slots, but will operate at the lowest common speed. ECC protection adds single-bit correction without registered buffering overhead.

Helstu kostir

  • 16 GB kit (2 × 8 GB) for Synology RS1619xs+ and RS2818RP+
  • DDR4 2666 MHz CL19 ECC unbuffered UDIMM for data integrity
  • JEDEC-standard 1.2 V modules run cool without heat spreaders
  • Backward compatible with 2133 MHz and 2400 MHz systems
  • 288-pin 1Rx8 design installs easily in supported NAS units

Tæknilýsing

BrandOWC
Part Number2E6D41R8016P
Capacity16GB (2 x 8GB)
Type288-Pin DDR4 ECC UDIMM
SpeedDDR4 2666 (PC4 21300)
CAS LatencyCL19
Voltage1.2V
ECCYes
Buffered/RegisteredUnbuffered
Rank1Rx8
Heat SpreaderNo
Compatible SystemSynology RackstationRS1619xs+
Synology RackstationRS2818RP+

Aðrar útgáfur af þessari vöru

5 í viðbót í sama vöruflokki

Sama fjölskylda, mismunandi minni, kælingu eða klukkuhraða — berðu saman áður en þú ákveður þig.

Spurningar um þessa vöru

Will the 288-pin DDR4 UDIMM fit the memory slots in my Synology RS1619xs+?

Yes, the 288-pin DDR4 ECC UDIMM form factor matches the DIMM slots used in the Synology RS1619xs+ and RS2818RP+.

What is the correct way to seat the modules so the system recognises both 8GB sticks?

Align the notch on each module with the slot key, press down firmly until the side clips click shut on both ends.

Does the lack of a heat spreader mean I should plan to add active cooling later?

No, the modules run at standard 1.2V JEDEC voltage and are designed for passive airflow inside the NAS chassis.

Einnig í þessum vöruflokki

Fólk bar þetta saman

Sama hilla, sama greiðsluferli — átta myntir og 30 mínútna gengislæsing.