Við tökum við rafmynt — svo myntirnar sem þú átt geta keypt alvöru vélbúnað.Greiddu í rafmynt, eyddu henni í alvöru vélbúnað. Frí, tryggð sending um allan heim fyrir pantanir yfir 399 $. Hlutlausir pappakassar án merkinga, sendir frá Þýskalandi.Frí, tryggð sending yfir 399 $. Gengið þitt er læst í 30 mínútur um leið og greiðsluferlið hefst.Gengið læst í 30 mínútur. Hver vara er innsigluð, raðnúmer hennar yfirfarið, og hún nýtur 24 mánaða ábyrgðar.Innsiglað, með 24 mánaða ábyrgð.

Vaktaðar vörur Skrá inn
Green 240-pin DDR3 RDIMM module, no heat spreader

OWC

OWC 8GB DDR3 1600 ECC Registered RDIMM 1Rx4 240-pin 1.5V memory upgrade

SKU CH-SMMM-4G3NE

An 8 GB DDR3 ECC registered DIMM running at 1600 MHz for compatible Supermicro workstation and server boards

  • Capacity8GB
  • Type240-Pin DDR3 ECC RDIMM
  • SpeedDDR3 1600 (PC3 12800)
  • CAS LatencyCL11
  • Voltage1.5V
  • ECCYes

Capacity 8GB

  • ECC registered design prevents data corruption in servers
  • DDR3 1600 CL11 speed matches system specifications
  • 5 V operation meets JEDEC standard for DDR3
  • Single 8 GB 1Rx4 module fits 240-pin RDIMM slots
  • Validated for Supermicro H8 and X9DA7 motherboard series

Server ECC RDIMM upgrade

This OWC module is an 8 GB DDR3 1600 ECC Registered DIMM built for Supermicro H8DGG, H8QG6, H8QGI, H8SGL and X9DA7 motherboard series. It targets administrators extending the life of existing server or workstation platforms that require registered error-correcting memory.

240-pin registered form factor

The stick uses a standard 240-pin DDR3 interface and operates at 1.5 V with CL11 latency. Because it is registered, it cannot be mixed with unbuffered modules and will not function in standard desktop boards that lack registered memory support.

Single 8 GB 1Rx4 capacity

Each module provides one rank of 1Rx4 organisation, delivering 8 GB per slot. Systems needing higher density per DIMM or unbuffered ECC memory will not be compatible with this part.

Helstu kostir

  • ECC registered design prevents data corruption in servers
  • DDR3 1600 CL11 speed matches system specifications
  • 5 V operation meets JEDEC standard for DDR3
  • Single 8 GB 1Rx4 module fits 240-pin RDIMM slots
  • Validated for Supermicro H8 and X9DA7 motherboard series

Tæknilýsing

BrandOWC
Part Number1R6D31R408GB
Capacity8GB
Type240-Pin DDR3 ECC RDIMM
SpeedDDR3 1600 (PC3 12800)
CAS LatencyCL11
Voltage1.5V
ECCYes
Buffered/RegisteredRegistered
Rank1Rx4
Heat SpreaderNo
Compatible SystemSupermicro Motherboard H8DGG Series
Supermicro Motherboard H8QG6 Series
Supermicro Motherboard H8QGI Series
Supermicro Motherboard H8SGL Series
Supermicro Motherboard X9DA7 Series

Aðrar útgáfur af þessari vöru

5 í viðbót í sama vöruflokki

Sama fjölskylda, mismunandi minni, kælingu eða klukkuhraða — berðu saman áður en þú ákveður þig.

Spurningar um þessa vöru

Does DDR3-1600 PC3-12800 CL11 cap the memory bus at 1600 MT/s on these Supermicro boards?

Yes, the module runs at DDR3 1600 with CL11 timing, so the data rate is limited to 1600 MT/s on the supported H8DGG, H8QG6, H8QGI, H8SGL and X9DA7 motherboards.

What physical slot and clearance does the 240-pin 1Rx4 RDIMM require?

It fits a standard 240-pin DDR3 DIMM socket; the module has no heat spreader, so low-profile CPU coolers or dense server chassis will not interfere.

How is the ECC registered DIMM installed, and what step is often missed?

Power down the server, open the chassis, align the notch on the 240-pin edge connector, press firmly until both retention clips click, then verify in BIOS that ECC and registered mode are enabled for the new module.

Einnig í þessum vöruflokki

Fólk bar þetta saman

Sama hilla, sama greiðsluferli — átta myntir og 30 mínútna gengislæsing.