Við tökum við rafmynt — svo myntirnar sem þú átt geta keypt alvöru vélbúnað.Greiddu í rafmynt, eyddu henni í alvöru vélbúnað. Frí, tryggð sending um allan heim fyrir pantanir yfir 399 $. Hlutlausir pappakassar án merkinga, sendir frá Þýskalandi.Frí, tryggð sending yfir 399 $. Gengið þitt er læst í 30 mínútur um leið og greiðsluferlið hefst.Gengið læst í 30 mínútur. Hver vara er innsigluð, raðnúmer hennar yfirfarið, og hún nýtur 24 mánaða ábyrgðar.Innsiglað, með 24 mánaða ábyrgð.

Vaktaðar vörur Skrá inn
Silver 3.5-inch bare hard drive with exposed circuit board

Western Digital

Western Digital WD5002ABYS 500GB 7200 RPM 16MB SATA 3.0Gb/s 3.5" internal hard drive

SKU CH-DXNZ-6QV3Y MPN WD5002ABYS

500 GB desktop hard drive spinning at 7200 RPM with 16 MB cache and SATA 3.0 Gb/s interface

  • PackagingBare Drive
  • InterfaceSATA 3.0Gb/s
  • Capacity500GB
  • RPM7200 RPM
  • Cache16MB
  • Average Latency4.2ms
  • 500 GB capacity stores large media libraries
  • 7200 RPM spindle speed delivers responsive desktop performance
  • 16 MB cache buffers bursts for smoother multitasking
  • SATA 3.0 Gb/s interface fits standard motherboard ports
  • 5 inch form factor installs in any desktop bay

RE3 enterprise drive for desktop

The Western Digital RE3 WD5002ABYS is a 3.5-inch internal hard drive built for desktop workloads. It offers 500GB of capacity on a SATA 3.0Gb/s interface with a 7200 RPM spindle speed and 16MB cache. The drive arrives as a bare unit, erased to DoD 5220.22 M standard and tested for working condition. It is sold new without formatting or partitioning applied.

Suits RAID and archive duties

This drive suits builders adding bulk storage to a desktop, a home server or a RAID array where 7200 RPM throughput matters. The 16MB cache and 4.2ms average latency support steady sequential workloads. Buyers who need a boot drive with faster random access or who require a larger single volume should look at something else. The bare-drive packaging means no cables or mounting screws are included.

SATA 3.0Gb/s interface decides fit

The single specification that decides compatibility is the SATA 3.0Gb/s interface. Your motherboard or controller must provide a standard SATA port running at 3.0Gb/s or higher to use this drive. A 3.5-inch drive bay and a SATA power connector are also required. Verify these connections before purchase.

Helstu kostir

  • 500 GB capacity stores large media libraries
  • 7200 RPM spindle speed delivers responsive desktop performance
  • 16 MB cache buffers bursts for smoother multitasking
  • SATA 3.0 Gb/s interface fits standard motherboard ports
  • 5 inch form factor installs in any desktop bay

Tæknilýsing

BrandWestern Digital
SeriesRE3
ModelWD5002ABYS
PackagingBare Drive
InterfaceSATA 3.0Gb/s
Capacity500GB
RPM7200 RPM
Cache16MB
Average Latency4.2ms
FeaturesErased (DoD 5220.22 M Compliant) and tested good (Not formatted, partitioned, or allocated). Sold as used and in working condition. There may be drives that have up to 50 bad sectors. There may be writing or markings on the drive or the drive may vary slightly (color and/or label may differ) from picture but the model numbers will be the same.
Form Factor3.5"
Sendingarþyngd0.91 kg
Stærð sendingar147 × 102 × 25 mm

Spurningar um þessa vöru

How much power and heat does the WD5002ABYS produce when running continuously?

The 7200 RPM spindle and 16 MB cache draw typical desktop 3.5" drive power; expect normal operating warmth and audible seek noise during sustained use.

What existing hardware is required to install this SATA 3.0Gb/s drive?

You need a free SATA data port on the motherboard or controller, a matching SATA power connector from the PSU, and a 3.5" drive bay or mounting bracket.

Will the WD5002ABYS work alongside an older IDE drive in the same system?

Yes, the SATA interface operates independently of legacy IDE channels; both drives can coexist if the board provides both connector types.

Einnig í þessum vöruflokki

Fólk bar þetta saman

Sama hilla, sama greiðsluferli — átta myntir og 30 mínútna gengislæsing.