Við tökum við rafmynt — svo myntirnar sem þú átt geta keypt alvöru vélbúnað.Greiddu í rafmynt, eyddu henni í alvöru vélbúnað. Frí, tryggð sending um allan heim fyrir pantanir yfir 399 $. Hlutlausir pappakassar án merkinga, sendir frá Þýskalandi.Frí, tryggð sending yfir 399 $. Gengið þitt er læst í 30 mínútur um leið og greiðsluferlið hefst.Gengið læst í 30 mínútur. Hver vara er innsigluð, raðnúmer hennar yfirfarið, og hún nýtur 24 mánaða ábyrgðar.Innsiglað, með 24 mánaða ábyrgð.

Vaktaðar vörur Skrá inn
Black 80mm square case fan with ball bearing and 3-pin connector

Zyvpee

Zyvpee AD0812UF-A73GL 80mm 12V .30A 3-pin ball bearing case fan

SKU CH-RA6Y-PBGY2

80 mm ball-bearing case fan runs on 12 V at .30 A with a three-pin connector

  • TypeCase Fan
  • Bearing TypeBall
  • Power Connector3 Pin
  • ColorBlack
  • LEDNon-LED
  • FeaturesCPU Fan
  • Ball bearing design extends service life
  • 12 V .30 A draws minimal power from the supply
  • 80 mm frame fits tight chassis spaces
  • 25 mm thickness matches standard mounting holes
  • Three-pin connector enables speed monitoring

Compact 80 mm case fan

The Zyvpee AD0812UF-A73GL is an 80 mm square frame fan with a 25 mm thickness. It runs on 12 V DC at 0.30 A and connects through a standard three-pin power header. The black, non-LED housing suits builds that prefer a neutral look.

Ball-bearing motor only

The unit uses a ball bearing rather than a sleeve or fluid-dynamic type. No speed-control cable, RGB lighting, vibration pads or mounting screws are included in the package. The three-pin connector reports rotational speed but does not support PWM regulation.

Direct three-pin mounting

Installation means aligning the four corner holes with the case or heatsink brackets and securing the fan with user-supplied screws. The short lead reaches nearby headers on most boards; longer runs need an extension cable. Polarity is fixed, so reversing the plug will prevent the fan from spinning.

Helstu kostir

  • Ball bearing design extends service life
  • 12 V .30 A draws minimal power from the supply
  • 80 mm frame fits tight chassis spaces
  • 25 mm thickness matches standard mounting holes
  • Three-pin connector enables speed monitoring

Tæknilýsing

Brand3ccooler.com
SeriesAD0812UF-A73GL
ModelAD0812UF-A73GL
TypeCase Fan
Bearing TypeBall
Power Connector3 Pin
ColorBlack
LEDNon-LED
FeaturesCPU Fan
Dimensions80*25mm

Spurningar um þessa vöru

How often will the ball bearing in this AD0812UF-A73GL fan need replacement?

Ball bearings typically run for tens of thousands of hours before wear becomes noticeable; the 12 V, 0.30 A motor draws minimal current, reducing thermal stress on the bearing surfaces.

What limit appears first when this 80 mm fan runs continuously at full voltage?

The 0.30 A current rating sets the electrical ceiling; sustained operation at 12 V will not exceed this draw, so the motor’s thermal envelope is the practical limit.

How much noise and heat does the 8025-size unit produce during all-day use?

At 80 mm diameter and 25 mm thickness, the LF-bearing design moves air quietly; the low 0.30 A draw keeps coil heat modest even after hours of continuous spinning.

Einnig í þessum vöruflokki

Fólk bar þetta saman

Sama hilla, sama greiðsluferli — átta myntir og 30 mínútna gengislæsing.