Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Black 80mm square case fan with ball bearing and 3-pin connector

Zyvpee

Zyvpee AD0812UF-A73GL 80mm 12V .30A 3-pin ball bearing case fan

SKU CH-RA6Y-PBGY2

80 mm ball-bearing case fan runs on 12 V at .30 A with a three-pin connector

  • TypeCase Fan
  • Bearing TypeBall
  • Power Connector3 Pin
  • ColorBlack
  • LEDNon-LED
  • FeaturesCPU Fan
  • Ball bearing design extends service life
  • 12 V .30 A draws minimal power from the supply
  • 80 mm frame fits tight chassis spaces
  • 25 mm thickness matches standard mounting holes
  • Three-pin connector enables speed monitoring

Compact 80 mm case fan

The Zyvpee AD0812UF-A73GL is an 80 mm square frame fan with a 25 mm thickness. It runs on 12 V DC at 0.30 A and connects through a standard three-pin power header. The black, non-LED housing suits builds that prefer a neutral look.

Ball-bearing motor only

The unit uses a ball bearing rather than a sleeve or fluid-dynamic type. No speed-control cable, RGB lighting, vibration pads or mounting screws are included in the package. The three-pin connector reports rotational speed but does not support PWM regulation.

Direct three-pin mounting

Installation means aligning the four corner holes with the case or heatsink brackets and securing the fan with user-supplied screws. The short lead reaches nearby headers on most boards; longer runs need an extension cable. Polarity is fixed, so reversing the plug will prevent the fan from spinning.

Kohokohdat

  • Ball bearing design extends service life
  • 12 V .30 A draws minimal power from the supply
  • 80 mm frame fits tight chassis spaces
  • 25 mm thickness matches standard mounting holes
  • Three-pin connector enables speed monitoring

Tekniset tiedot

Brand3ccooler.com
SeriesAD0812UF-A73GL
ModelAD0812UF-A73GL
TypeCase Fan
Bearing TypeBall
Power Connector3 Pin
ColorBlack
LEDNon-LED
FeaturesCPU Fan
Dimensions80*25mm

Kysymyksiä tästä tuotteesta

How often will the ball bearing in this AD0812UF-A73GL fan need replacement?

Ball bearings typically run for tens of thousands of hours before wear becomes noticeable; the 12 V, 0.30 A motor draws minimal current, reducing thermal stress on the bearing surfaces.

What limit appears first when this 80 mm fan runs continuously at full voltage?

The 0.30 A current rating sets the electrical ceiling; sustained operation at 12 V will not exceed this draw, so the motor’s thermal envelope is the practical limit.

How much noise and heat does the 8025-size unit produce during all-day use?

At 80 mm diameter and 25 mm thickness, the LF-bearing design moves air quietly; the low 0.30 A draw keeps coil heat modest even after hours of continuous spinning.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.