Priimame kriptovaliutą — taip monetos, kurias turite, gali nupirkti tikrą techniką.Mokėkite kriptovaliuta, išleiskite ją tikrai technikai. Nemokamas apdraustas pristatymas visame pasaulyje virš 399 $. Paprastos, be žymų siuntos dėžės, siunčiamos iš Vokietijos.Nemokamas apdraustas pristatymas virš 399 $. Jūsų kursas fiksuojamas 30 minučių, kai tik prasideda atsiskaitymas.Kursas fiksuojamas 30 minučių. Kiekvienas gaminys užplombuotas, jo serijos numeris patikrintas, ir jam taikoma 24 mėnesių garantija.Užplombuota, 24 mėnesių garantija.

Stebimos prekės Prisijungti
Green rectangular circuit board with black memory chips and gold edge connectors

SK hynix

SK hynix HMT451U7BFR8A-PB 4GB DDR3 1600MHz ECC Unbuffered CL11 1.35V server RAM

SKU CH-MGB1-V2Y13

4GB DDR3 ECC server memory running at 1600MHz with CL11 latency and low 1.35V operation

  • ECC protection safeguards data integrity in server workloads
  • 35 V operation lowers power draw versus standard DDR3
  • 1600 MHz speed delivers 12 800 MB/s bandwidth for responsive performance
  • Single-rank design keeps electrical load light for stable operation
  • 240-pin DIMM fits standard DDR3 server memory slots

4 GB DDR3 ECC unbuffered module

This 4 GB DDR3 module runs at 1600 MHz with a CL11 latency and 1.35 V operating voltage. It uses a 240-pin DIMM form factor and presents a single-rank 1Rx8 organisation. Error-correcting code is built in for data integrity.

Suits HP servers needing ECC unbuffered DDR3

Buyers who need registered or load-reduced memory should look elsewhere, as this module is unbuffered only. Systems that require 1.5 V standard-voltage DDR3 cannot use this 1.35 V part. Capacity per slot is fixed at 4 GB.

1.35 V low-voltage DDR3 specification

The 1.35 V rating is the single spec that decides fitment; the motherboard must explicitly support this voltage level. If the platform only accepts 1.5 V DDR3, the module will not function correctly.

Privalumai

  • ECC protection safeguards data integrity in server workloads
  • 35 V operation lowers power draw versus standard DDR3
  • 1600 MHz speed delivers 12 800 MB/s bandwidth for responsive performance
  • Single-rank design keeps electrical load light for stable operation
  • 240-pin DIMM fits standard DDR3 server memory slots

Specifikacijos

Šiai prekei specifikacijos dar nepaskelbtos.

Klausimai apie šią prekę

Will the ECC function on this 4 GB DDR3 module require any firmware updates or periodic reconfiguration during its service life?

ECC operates in hardware with no firmware updates or reconfiguration needed; the module simply detects and corrects single-bit errors as long as it remains seated in the 240-pin slot.

What is the first limit reached when this CL11 1600 MHz DIMM runs at full load continuously?

The CAS latency of 11 cycles at 1.25 ns per cycle sets the timing boundary; sustained throughput cannot exceed the PC3-12800 data rate of 1600 MT/s.

How much heat and power does the 1.35 V 4 GB stick produce when installed in a server running 24/7?

At 1.35 V the module draws less power than standard 1.5 V DDR3, so heat output stays low and typical server airflow is sufficient for continuous operation.

Taip pat šiame skyriuje

Kiti pirkėjai taip pat lygino

Ta pati lentyna, tas pats atsiskaitymas — aštuonios monetos ir 30 minučių fiksuotas kursas.