Mēs pieņemam kriptovalūtu — lai tā, kas Jums pieder, varētu nopirkt īstu aparatūru.Maksājiet kriptovalūtā, iztērējiet to īstai aparatūrai. Bezmaksas apdrošināta piegāde visā pasaulē virs 399 $. Vienkāršas, nemarķētas kastes, sūtītas no Vācijas.Bezmaksas apdrošināta piegāde virs 399 $. Jūsu kurss tiek fiksēts uz 30 minūtēm, tiklīdz atveras kase.Kurss fiksēts uz 30 minūtēm. Katra prece ir aizzīmogota, tās sērijas numurs ir pārbaudīts, un uz to attiecas 24 mēnešu garantija.Aizzīmogots, 24 mēnešu garantija.

Uzraudzītās preces Pieteikties
Green rectangular circuit board with black memory chips and gold edge connectors

SK hynix

SK hynix HMT451U7BFR8A-PB 4GB DDR3 1600MHz ECC Unbuffered CL11 1.35V server RAM

SKU CH-MGB1-V2Y13

4GB DDR3 ECC server memory running at 1600MHz with CL11 latency and low 1.35V operation

  • ECC protection safeguards data integrity in server workloads
  • 35 V operation lowers power draw versus standard DDR3
  • 1600 MHz speed delivers 12 800 MB/s bandwidth for responsive performance
  • Single-rank design keeps electrical load light for stable operation
  • 240-pin DIMM fits standard DDR3 server memory slots

4 GB DDR3 ECC unbuffered module

This 4 GB DDR3 module runs at 1600 MHz with a CL11 latency and 1.35 V operating voltage. It uses a 240-pin DIMM form factor and presents a single-rank 1Rx8 organisation. Error-correcting code is built in for data integrity.

Suits HP servers needing ECC unbuffered DDR3

Buyers who need registered or load-reduced memory should look elsewhere, as this module is unbuffered only. Systems that require 1.5 V standard-voltage DDR3 cannot use this 1.35 V part. Capacity per slot is fixed at 4 GB.

1.35 V low-voltage DDR3 specification

The 1.35 V rating is the single spec that decides fitment; the motherboard must explicitly support this voltage level. If the platform only accepts 1.5 V DDR3, the module will not function correctly.

Priekšrocības

  • ECC protection safeguards data integrity in server workloads
  • 35 V operation lowers power draw versus standard DDR3
  • 1600 MHz speed delivers 12 800 MB/s bandwidth for responsive performance
  • Single-rank design keeps electrical load light for stable operation
  • 240-pin DIMM fits standard DDR3 server memory slots

Specifikācijas

Šai precei pagaidām nav publicētu specifikāciju.

Jautājumi par šo preci

Will the ECC function on this 4 GB DDR3 module require any firmware updates or periodic reconfiguration during its service life?

ECC operates in hardware with no firmware updates or reconfiguration needed; the module simply detects and corrects single-bit errors as long as it remains seated in the 240-pin slot.

What is the first limit reached when this CL11 1600 MHz DIMM runs at full load continuously?

The CAS latency of 11 cycles at 1.25 ns per cycle sets the timing boundary; sustained throughput cannot exceed the PC3-12800 data rate of 1600 MT/s.

How much heat and power does the 1.35 V 4 GB stick produce when installed in a server running 24/7?

At 1.35 V the module draws less power than standard 1.5 V DDR3, so heat output stays low and typical server airflow is sufficient for continuous operation.

Arī šajā sadaļā

Klienti arī salīdzināja

Tas pats plaukts, tā pati kase — astoņas kriptovalūtas un kursa fiksēšana uz 30 minūtēm.