暗号資産でのお支払いに対応—お手持ちのコインで、本物のハードウェアをご購入いただけます。暗号資産で支払い、本物のハードウェアに使う。 $399以上のご注文で、世界中どこでも送料無料（保険付き）。無地・ノーブランドの外箱で、ドイツから発送いたします。$399以上で送料無料（保険付き）。 注文手続きを開始すると、レートは30分間ロックされます。レートは30分間ロック。 すべての商品は未開封で、シリアル番号を確認した上で、24か月保証が付いています。未開封、24か月保証。

ウォッチリスト ログイン
Green rectangular circuit board with black memory chips and gold edge connectors

SK hynix

SK hynix HMT451U7BFR8A-PB 4GB DDR3 1600MHz ECC Unbuffered CL11 1.35V server RAM

SKU CH-MGB1-V2Y13

4GB DDR3 ECC server memory running at 1600MHz with CL11 latency and low 1.35V operation

  • ECC protection safeguards data integrity in server workloads
  • 35 V operation lowers power draw versus standard DDR3
  • 1600 MHz speed delivers 12 800 MB/s bandwidth for responsive performance
  • Single-rank design keeps electrical load light for stable operation
  • 240-pin DIMM fits standard DDR3 server memory slots

4 GB DDR3 ECC unbuffered module

This 4 GB DDR3 module runs at 1600 MHz with a CL11 latency and 1.35 V operating voltage. It uses a 240-pin DIMM form factor and presents a single-rank 1Rx8 organisation. Error-correcting code is built in for data integrity.

Suits HP servers needing ECC unbuffered DDR3

Buyers who need registered or load-reduced memory should look elsewhere, as this module is unbuffered only. Systems that require 1.5 V standard-voltage DDR3 cannot use this 1.35 V part. Capacity per slot is fixed at 4 GB.

1.35 V low-voltage DDR3 specification

The 1.35 V rating is the single spec that decides fitment; the motherboard must explicitly support this voltage level. If the platform only accepts 1.5 V DDR3, the module will not function correctly.

特長

  • ECC protection safeguards data integrity in server workloads
  • 35 V operation lowers power draw versus standard DDR3
  • 1600 MHz speed delivers 12 800 MB/s bandwidth for responsive performance
  • Single-rank design keeps electrical load light for stable operation
  • 240-pin DIMM fits standard DDR3 server memory slots

仕様

この商品の仕様はまだ公開されていません。

この商品に関する質問

Will the ECC function on this 4 GB DDR3 module require any firmware updates or periodic reconfiguration during its service life?

ECC operates in hardware with no firmware updates or reconfiguration needed; the module simply detects and corrects single-bit errors as long as it remains seated in the 240-pin slot.

What is the first limit reached when this CL11 1600 MHz DIMM runs at full load continuously?

The CAS latency of 11 cycles at 1.25 ns per cycle sets the timing boundary; sustained throughput cannot exceed the PC3-12800 data rate of 1600 MT/s.

How much heat and power does the 1.35 V 4 GB stick produce when installed in a server running 24/7?

At 1.35 V the module draws less power than standard 1.5 V DDR3, so heat output stays low and typical server airflow is sufficient for continuous operation.

同じ売り場の商品

よく比較されている商品

同じ売り場、同じレジ — 8種類のコインと30分間のレートロック。