OWC 8GB DDR3 1333 PC3-10600 CL9 2Rx4 240-pin 1.5V ECC Registered RDIMM for Dell PowerEdge R610 R710
- 8GB
- 240-Pin DDR3 ECC RD…
Mēs pieņemam kriptovalūtu — lai tā, kas Jums pieder, varētu nopirkt īstu aparatūru.Maksājiet kriptovalūtā, iztērējiet to īstai aparatūrai. Bezmaksas apdrošināta piegāde visā pasaulē virs 399 $. Vienkāršas, nemarķētas kastes, sūtītas no Vācijas.Bezmaksas apdrošināta piegāde virs 399 $. Jūsu kurss tiek fiksēts uz 30 minūtēm, tiklīdz atveras kase.Kurss fiksēts uz 30 minūtēm. Katra prece ir aizzīmogota, tās sērijas numurs ir pārbaudīts, un uz to attiecas 24 mēnešu garantija.Aizzīmogots, 24 mēnešu garantija.
OWC
An 8 GB DDR3-1333 ECC registered DIMM validated for the HP Z600 workstation
Capacity 8GB
This 8GB DDR3 module is built for the HP Workstation Z600 and replaces several original HP part numbers. It is an ECC Registered RDIMM, so it will not work in standard desktop computers and cannot be mixed with unbuffered memory.
The stick runs at the standard JEDEC voltage of 1.5V and has no heat spreader, relying on the Z600's internal airflow for cooling. Registered buffering adds a small electrical load but keeps signal integrity high in multi-DIMM configurations typical of this workstation.
Under continuous workloads the ECC circuitry detects and corrects single-bit errors without halting the system, preserving data integrity over long render or compute sessions. The CL9 latency at 1333 MT/s delivers steady throughput as long as the platform's memory controller and cooling remain within specification.
| Brand | OWC |
|---|---|
| Part Number | 1R3D32R408GB |
| Capacity | 8GB |
| Type | 240-Pin DDR3 ECC RDIMM |
| Speed | DDR3 1333 (PC3 10600) |
| CAS Latency | CL9 |
| Voltage | 1.5V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 2Rx4 |
| Heat Spreader | No |
| Compatible System | HP Workstation Z600 |
Citas šī modeļa versijas
Viena saime, taču atšķirīga atmiņa, dzesētājs vai frekvence — salīdziniet, pirms izlemjat.
Power off the workstation, open the case, align the notch on the module with the slot key, press firmly until the retention clips snap shut, then verify in BIOS that the 8 GB module is recognised at 1333 MHz; the step often missed is confirming the memory runs in registered ECC mode rather than defaulting to a lower speed.
No routine maintenance is required; the module has no heat spreader and no moving parts. Replacement is only necessary if a memory test reports correctable or uncorrectable ECC errors, at which point you would swap in another 8 GB DDR3 1333 PC3-10600 CL9 2Rx4 registered DIMM.
The memory controller’s maximum supported frequency of 1333 MHz is the first ceiling; the module cannot exceed its rated DDR3 1333 speed, so sustained heavy use will hit that bandwidth limit before thermal or voltage constraints become an issue.
Arī šajā sadaļā
Tas pats plaukts, tā pati kase — astoņas kriptovalūtas un kursa fiksēšana uz 30 minūtēm.
Kriptovalūta, kurā maksājat, un valūta, kurā redzat cenas.
Nosūtīts no Jūsu maciņa, noformējot pasūtījumu
Tikai informatīvi — katalogā cenas norādītas ASV dolāros
Neviena valūta neatbilst.
Izvēlieties valodu, kurā vietne sarunājas ar Jums.
Neviena valoda neatbilst.
Pirmo reizi šeit?
Jau ir konts?
Automātiskas atiestatīšanas nav: šis veikals nesūta e-pastus, tāpēc nav arī vienreizējas saites, ko pieprasīt. Atstājiet adresi kontā, un tā tiks apstrādāta manuāli.
Pieprasījums saņemts
Uz Jūsu e-pastu nekas neatnāks — šis veikals vispār nesūta e-pastus. Kāds šos pieprasījumus apstrādā manuāli.
Atcerējāties?