저희는 암호화폐로 결제를 받습니다 — 보유하신 코인으로 실제 하드웨어를 구매하실 수 있습니다.암호화폐로 결제하고, 실제 하드웨어 구매에 사용하십시오. 전 세계 어디서나 US$399 이상 구매 시 무료 보험 배송. 무지 상자에 담아 독일에서 발송합니다.US$399 이상 구매 시 무료 보험 배송. 체크아웃을 시작하면 30분 동안 환율이 잠깁니다.30분간 환율 잠금. 모든 제품은 밀봉된 상태로 일련번호를 확인한 후 24개월 보증을 제공합니다.밀봉 포장, 24개월 보증.

가격 추적 로그인
Green circuit board with black memory chips and gold edge connectors

OWC

OWC 8GB DDR3 1333 PC3-10600 CL9 2Rx4 240-pin 1.5V ECC Registered RDIMM HP Z600 memory upgrade

SKU CH-CFG3-F5G1Y

An 8 GB DDR3-1333 ECC registered DIMM validated for the HP Z600 workstation

  • Capacity8GB
  • Type240-Pin DDR3 ECC RDIMM
  • SpeedDDR3 1333 (PC3 10600)
  • CAS LatencyCL9
  • Voltage1.5V
  • ECCYes

Capacity 8GB

  • ECC Registered design protects data integrity in HP Z600 workstations
  • 8 GB DDR3 1333 MHz module boosts multitasking capacity
  • 240-pin RDIMM form factor fits HP Z600 memory slots
  • 5 V CL9 timing meets JEDEC PC3-10600 specification
  • Replaces HP part numbers 500205071 500205171 500206071 500662B21 501536001 593913B21 A0R56A FX622AA FX622UT

Targeted Workstation Upgrade

This 8GB DDR3 module is built for the HP Workstation Z600 and replaces several original HP part numbers. It is an ECC Registered RDIMM, so it will not work in standard desktop computers and cannot be mixed with unbuffered memory.

Thermals and Power

The stick runs at the standard JEDEC voltage of 1.5V and has no heat spreader, relying on the Z600's internal airflow for cooling. Registered buffering adds a small electrical load but keeps signal integrity high in multi-DIMM configurations typical of this workstation.

Sustained Load Behaviour

Under continuous workloads the ECC circuitry detects and corrects single-bit errors without halting the system, preserving data integrity over long render or compute sessions. The CL9 latency at 1333 MT/s delivers steady throughput as long as the platform's memory controller and cooling remain within specification.

주요 특징

  • ECC Registered design protects data integrity in HP Z600 workstations
  • 8 GB DDR3 1333 MHz module boosts multitasking capacity
  • 240-pin RDIMM form factor fits HP Z600 memory slots
  • 5 V CL9 timing meets JEDEC PC3-10600 specification
  • Replaces HP part numbers 500205071 500205171 500206071 500662B21 501536001 593913B21 A0R56A FX622AA FX622UT

사양

BrandOWC
Part Number1R3D32R408GB
Capacity8GB
Type240-Pin DDR3 ECC RDIMM
SpeedDDR3 1333 (PC3 10600)
CAS LatencyCL9
Voltage1.5V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx4
Heat SpreaderNo
Compatible SystemHP Workstation Z600

이 모델의 다른 버전

같은 라인업에서 5개 더

같은 제품군에서 메모리·쿨러·클럭이 다릅니다 — 결정 전에 비교해 보세요.

이 상품에 대한 질문

How do I install this 240-pin DDR3 RDIMM in my HP Z600, and what step is commonly missed?

Power off the workstation, open the case, align the notch on the module with the slot key, press firmly until the retention clips snap shut, then verify in BIOS that the 8 GB module is recognised at 1333 MHz; the step often missed is confirming the memory runs in registered ECC mode rather than defaulting to a lower speed.

What maintenance or replacement will this ECC registered module need over time?

No routine maintenance is required; the module has no heat spreader and no moving parts. Replacement is only necessary if a memory test reports correctable or uncorrectable ECC errors, at which point you would swap in another 8 GB DDR3 1333 PC3-10600 CL9 2Rx4 registered DIMM.

What limit appears first when this 1.5 V RDIMM runs sustained workloads on the Z600?

The memory controller’s maximum supported frequency of 1333 MHz is the first ceiling; the module cannot exceed its rated DDR3 1333 speed, so sustained heavy use will hit that bandwidth limit before thermal or voltage constraints become an issue.

이 진열대의 다른 상품

고객들이 함께 비교한 상품

같은 진열대, 같은 체크아웃 — 코인 8종, 환율 잠금 30분.