OWC 8GB DDR3 1333 PC3-10600 CL9 2Rx4 240-pin 1.5V ECC Registered RDIMM for Dell PowerEdge R610 R710
- 8GB
- 240-Pin DDR3 ECC RD…
Приемаме криптовалута — така монетите, които притежавате, могат да купят истински хардуер.Платете с крипто, похарчете го за истински хардуер. Безплатна застрахована доставка по целия свят над 399 $. Неутрални кашони без марка, изпратени от Германия.Безплатна застрахована доставка над 399 $. Курсът Ви е заключен за 30 минути веднага след отварянето на касата.Курс, заключен за 30 минути. Всеки артикул е запечатан, серийният му номер е проверен, и е покрит с 24-месечна гаранция.Запечатан, 24-месечна гаранция.
OWC
An 8 GB DDR3-1333 ECC registered DIMM validated for the HP Z600 workstation
Capacity 8GB
This 8GB DDR3 module is built for the HP Workstation Z600 and replaces several original HP part numbers. It is an ECC Registered RDIMM, so it will not work in standard desktop computers and cannot be mixed with unbuffered memory.
The stick runs at the standard JEDEC voltage of 1.5V and has no heat spreader, relying on the Z600's internal airflow for cooling. Registered buffering adds a small electrical load but keeps signal integrity high in multi-DIMM configurations typical of this workstation.
Under continuous workloads the ECC circuitry detects and corrects single-bit errors without halting the system, preserving data integrity over long render or compute sessions. The CL9 latency at 1333 MT/s delivers steady throughput as long as the platform's memory controller and cooling remain within specification.
| Brand | OWC |
|---|---|
| Part Number | 1R3D32R408GB |
| Capacity | 8GB |
| Type | 240-Pin DDR3 ECC RDIMM |
| Speed | DDR3 1333 (PC3 10600) |
| CAS Latency | CL9 |
| Voltage | 1.5V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 2Rx4 |
| Heat Spreader | No |
| Compatible System | HP Workstation Z600 |
Други версии на този модел
Същото семейство, различна памет, охладител или честота — сравнете, преди да решите.
Power off the workstation, open the case, align the notch on the module with the slot key, press firmly until the retention clips snap shut, then verify in BIOS that the 8 GB module is recognised at 1333 MHz; the step often missed is confirming the memory runs in registered ECC mode rather than defaulting to a lower speed.
No routine maintenance is required; the module has no heat spreader and no moving parts. Replacement is only necessary if a memory test reports correctable or uncorrectable ECC errors, at which point you would swap in another 8 GB DDR3 1333 PC3-10600 CL9 2Rx4 registered DIMM.
The memory controller’s maximum supported frequency of 1333 MHz is the first ceiling; the module cannot exceed its rated DDR3 1333 speed, so sustained heavy use will hit that bandwidth limit before thermal or voltage constraints become an issue.
Още от този рафт
Същият рафт, същата каса — осем монети и заключване на курса за 30 минути.
Това, което изпращате, и това, в което четете цените.
Изпратено от Вашия портфейл при поръчката
Само за визуализация — каталогът е в долари
Никоя валута не съответства.
Изберете езика, на който сайтът да Ви говори.
Няма съвпадащ език.
Нови сте тук?
Вече имате профил?
Няма автоматично нулиране: този магазин не изпраща имейли, така че няма еднократна връзка, която да поискате. Оставете адреса в профила си и той ще бъде обработен ръчно.
Заявката е приета
Нищо няма да пристигне във Вашата пощенска кутия — този магазин изобщо не изпраща имейли. Заявките се обработват ръчно.
Спомнихте си я?