Mēs pieņemam kriptovalūtu — lai tā, kas Jums pieder, varētu nopirkt īstu aparatūru.Maksājiet kriptovalūtā, iztērējiet to īstai aparatūrai. Bezmaksas apdrošināta piegāde visā pasaulē virs 399 $. Vienkāršas, nemarķētas kastes, sūtītas no Vācijas.Bezmaksas apdrošināta piegāde virs 399 $. Jūsu kurss tiek fiksēts uz 30 minūtēm, tiklīdz atveras kase.Kurss fiksēts uz 30 minūtēm. Katra prece ir aizzīmogota, tās sērijas numurs ir pārbaudīts, un uz to attiecas 24 mēnešu garantija.Aizzīmogots, 24 mēnešu garantija.

Uzraudzītās preces Pieteikties
Green bare circuit board DDR3L ECC RDIMM module with black chips

OWC

OWC 8GB DDR3L 1600 CL11 ECC RDIMM 240-pin 1.35V Supermicro H8 Series memory upgrade

SKU CH-01MP-GP4CY

8GB DDR3L 1600 CL11 ECC registered DIMM for Supermicro H8 series servers

  • Capacity8GB
  • Type240-Pin DDR3L ECC RDIMM
  • SpeedDDR3L 1600 (PC3L 12800)
  • CAS LatencyCL11
  • Voltage1.35V
  • ECCYes

Capacity 8GB

  • ECC registered design protects data integrity in servers
  • 35 V DDR3L operation reduces power draw
  • 1600 MHz CL11 speed matches system requirements
  • Validated for Supermicro H8DCT, H8DG6, H8DGT, H8DGU, H8QG7
  • Single 8 GB 1Rx4 module simplifies capacity upgrades

8GB DDR3L ECC RDIMM for Supermicro H8

This 8GB DDR3L 1600 CL11 ECC registered DIMM is built for Supermicro H8 series server and workstation boards including the H8DCT, H8DG6, H8DGT, H8DGU and H8QG7 models. It runs at 1.35V and uses a 1Rx4 organisation. The module is not compatible with standard desktop computers or unbuffered memory configurations.

Installing the 240-pin RDIMM

Installation follows the usual DIMM procedure: power down the system, open the chassis, align the notch on the 240-pin module with the slot key and press firmly until the retention clips lock. Because this is registered ECC memory, it must not be mixed with unbuffered modules and the motherboard must support registered DIMMs; otherwise the system will not post.

DDR3L 1600 registered memory limits

The DDR3L 1600 PC3L-12800 interface tops out at 1600 MT/s with a CAS latency of 11 and a low 1.35V operating voltage. Registered signalling adds a clock cycle of buffering, which improves signal integrity on heavily populated boards but prevents use in platforms that only accept unbuffered DIMMs. Capacity per module is limited to the density of the 1Rx4 devices used here.

Priekšrocības

  • ECC registered design protects data integrity in servers
  • 35 V DDR3L operation reduces power draw
  • 1600 MHz CL11 speed matches system requirements
  • Validated for Supermicro H8DCT, H8DG6, H8DGT, H8DGU, H8QG7
  • Single 8 GB 1Rx4 module simplifies capacity upgrades

Specifikācijas

BrandOWC
Part Number1R6T31R408GB
Capacity8GB
Type240-Pin DDR3L ECC RDIMM
SpeedDDR3L 1600 (PC3L 12800)
CAS LatencyCL11
Voltage1.35V
ECCYes
Buffered/RegisteredRegistered
Rank1Rx4
Heat SpreaderNo
Compatible SystemSupermicro Motherboard H8DCT Series
Supermicro Motherboard H8DG6 Series
Supermicro Motherboard H8DGT Series
Supermicro Motherboard H8DGU Series
Supermicro Motherboard H8QG7 Series

Citas šī modeļa versijas

Vēl 5 šajā sērijā

Viena saime, taču atšķirīga atmiņa, dzesētājs vai frekvence — salīdziniet, pirms izlemjat.

Jautājumi par šo preci

How can I confirm the 8GB DDR3L 1600 CL11 module is running at 1.35V after installation?

Enter the BIOS or use a hardware monitor; the SPD data should show PC3L-12800 at 1.35V and the system must report ECC registered operation.

What ships in the box and what else is needed to add this memory?

The box contains one 8GB 240-pin DDR3L ECC RDIMM; no cables or tools are required, but an available registered DIMM slot on a supported H8-series board is necessary.

Which capacity or version should I pick for a Supermicro H8DCT board?

This listing is the single 8GB 1Rx4 DDR3L 1600 CL11 module; match the total capacity you need by adding identical modules to the board's registered DIMM slots.

Arī šajā sadaļā

Klienti arī salīdzināja

Tas pats plaukts, tā pati kase — astoņas kriptovalūtas un kursa fiksēšana uz 30 minūtēm.