Við tökum við rafmynt — svo myntirnar sem þú átt geta keypt alvöru vélbúnað.Greiddu í rafmynt, eyddu henni í alvöru vélbúnað. Frí, tryggð sending um allan heim fyrir pantanir yfir 399 $. Hlutlausir pappakassar án merkinga, sendir frá Þýskalandi.Frí, tryggð sending yfir 399 $. Gengið þitt er læst í 30 mínútur um leið og greiðsluferlið hefst.Gengið læst í 30 mínútur. Hver vara er innsigluð, raðnúmer hennar yfirfarið, og hún nýtur 24 mánaða ábyrgðar.Innsiglað, með 24 mánaða ábyrgð.

Vaktaðar vörur Skrá inn
Green bare circuit board DDR3L ECC RDIMM module with black chips

OWC

OWC 8GB DDR3L 1600 CL11 ECC RDIMM 240-pin 1.35V Supermicro H8 Series memory upgrade

SKU CH-01MP-GP4CY

8GB DDR3L 1600 CL11 ECC registered DIMM for Supermicro H8 series servers

  • Capacity8GB
  • Type240-Pin DDR3L ECC RDIMM
  • SpeedDDR3L 1600 (PC3L 12800)
  • CAS LatencyCL11
  • Voltage1.35V
  • ECCYes

Capacity 8GB

  • ECC registered design protects data integrity in servers
  • 35 V DDR3L operation reduces power draw
  • 1600 MHz CL11 speed matches system requirements
  • Validated for Supermicro H8DCT, H8DG6, H8DGT, H8DGU, H8QG7
  • Single 8 GB 1Rx4 module simplifies capacity upgrades

8GB DDR3L ECC RDIMM for Supermicro H8

This 8GB DDR3L 1600 CL11 ECC registered DIMM is built for Supermicro H8 series server and workstation boards including the H8DCT, H8DG6, H8DGT, H8DGU and H8QG7 models. It runs at 1.35V and uses a 1Rx4 organisation. The module is not compatible with standard desktop computers or unbuffered memory configurations.

Installing the 240-pin RDIMM

Installation follows the usual DIMM procedure: power down the system, open the chassis, align the notch on the 240-pin module with the slot key and press firmly until the retention clips lock. Because this is registered ECC memory, it must not be mixed with unbuffered modules and the motherboard must support registered DIMMs; otherwise the system will not post.

DDR3L 1600 registered memory limits

The DDR3L 1600 PC3L-12800 interface tops out at 1600 MT/s with a CAS latency of 11 and a low 1.35V operating voltage. Registered signalling adds a clock cycle of buffering, which improves signal integrity on heavily populated boards but prevents use in platforms that only accept unbuffered DIMMs. Capacity per module is limited to the density of the 1Rx4 devices used here.

Helstu kostir

  • ECC registered design protects data integrity in servers
  • 35 V DDR3L operation reduces power draw
  • 1600 MHz CL11 speed matches system requirements
  • Validated for Supermicro H8DCT, H8DG6, H8DGT, H8DGU, H8QG7
  • Single 8 GB 1Rx4 module simplifies capacity upgrades

Tæknilýsing

BrandOWC
Part Number1R6T31R408GB
Capacity8GB
Type240-Pin DDR3L ECC RDIMM
SpeedDDR3L 1600 (PC3L 12800)
CAS LatencyCL11
Voltage1.35V
ECCYes
Buffered/RegisteredRegistered
Rank1Rx4
Heat SpreaderNo
Compatible SystemSupermicro Motherboard H8DCT Series
Supermicro Motherboard H8DG6 Series
Supermicro Motherboard H8DGT Series
Supermicro Motherboard H8DGU Series
Supermicro Motherboard H8QG7 Series

Aðrar útgáfur af þessari vöru

5 í viðbót í sama vöruflokki

Sama fjölskylda, mismunandi minni, kælingu eða klukkuhraða — berðu saman áður en þú ákveður þig.

Spurningar um þessa vöru

How can I confirm the 8GB DDR3L 1600 CL11 module is running at 1.35V after installation?

Enter the BIOS or use a hardware monitor; the SPD data should show PC3L-12800 at 1.35V and the system must report ECC registered operation.

What ships in the box and what else is needed to add this memory?

The box contains one 8GB 240-pin DDR3L ECC RDIMM; no cables or tools are required, but an available registered DIMM slot on a supported H8-series board is necessary.

Which capacity or version should I pick for a Supermicro H8DCT board?

This listing is the single 8GB 1Rx4 DDR3L 1600 CL11 module; match the total capacity you need by adding identical modules to the board's registered DIMM slots.

Einnig í þessum vöruflokki

Fólk bar þetta saman

Sama hilla, sama greiðsluferli — átta myntir og 30 mínútna gengislæsing.