Mēs pieņemam kriptovalūtu — lai tā, kas Jums pieder, varētu nopirkt īstu aparatūru.Maksājiet kriptovalūtā, iztērējiet to īstai aparatūrai. Bezmaksas apdrošināta piegāde visā pasaulē virs 399 $. Vienkāršas, nemarķētas kastes, sūtītas no Vācijas.Bezmaksas apdrošināta piegāde virs 399 $. Jūsu kurss tiek fiksēts uz 30 minūtēm, tiklīdz atveras kase.Kurss fiksēts uz 30 minūtēm. Katra prece ir aizzīmogota, tās sērijas numurs ir pārbaudīts, un uz to attiecas 24 mēnešu garantija.Aizzīmogots, 24 mēnešu garantija.

Uzraudzītās preces Pieteikties
Green circuit board with black memory chips 262-pin SODIMM

OWC

OWC 8GB DDR5 4800 CL40 262-pin SODIMM memory upgrade for OptiPlex 7000 XE Micro 7010 Micro Plus

SKU CH-ZQXW-G6EET

8 GB DDR5-4800 SODIMM module for OptiPlex 7000 XE Micro and 7010 Micro Plus

  • Capacity8GB
  • Type262-Pin DDR5 Non-ECC SODIMM
  • SpeedDDR5 4800 (PC5 38400)
  • CAS LatencyCL40
  • Voltage1.1V
  • ECCNo
  • 8GB DDR5 4800 MHz boosts multitasking responsiveness
  • CL40 latency at 1.1V lowers power draw
  • 262-pin SODIMM fits OptiPlex 7000 XE Micro and 7010 Micro Plus
  • JEDEC and RoHS compliant for warranty-safe upgrades
  • Replaces Dell part numbers AB949333 SNPMVK8PC/8G

8GB DDR5 4800 SODIMM for OptiPlex Micro

This OWC module adds 8GB of DDR5 memory to compatible Dell OptiPlex systems. It runs at 4800 MT/s with CL40 latency at 1.1V. The 262-pin SODIMM fits the 7000 XE Micro and 7010 Micro Plus. It is an unbuffered, non-ECC 1Rx16 design without a heat spreader.

Suits single-slot upgrades on supported OptiPlex

Builders expanding a 7000 XE Micro or 7010 Micro Plus with one module will find this part validated for those chassis. Systems requiring ECC, registered DIMMs, or a different pin count cannot use this module. Buyers needing higher capacity per slot or a dual-rank configuration should look at other options.

4800 MT/s JEDEC speed with CL40 timing

The module operates at the standard DDR5 4800 data rate (PC5-38400) with a CAS latency of 40 cycles. This speed and timing are fixed by the JEDEC profile on the SPD. No higher frequency or tighter latency is programmed on this stick.

Priekšrocības

  • 8GB DDR5 4800 MHz boosts multitasking responsiveness
  • CL40 latency at 1.1V lowers power draw
  • 262-pin SODIMM fits OptiPlex 7000 XE Micro and 7010 Micro Plus
  • JEDEC and RoHS compliant for warranty-safe upgrades
  • Replaces Dell part numbers AB949333 SNPMVK8PC/8G

Specifikācijas

BrandOWC
Part Number4S8D51R608GB
Capacity8GB
Type262-Pin DDR5 Non-ECC SODIMM
SpeedDDR5 4800 (PC5 38400)
CAS LatencyCL40
Voltage1.1V
ECCNo
Buffered/RegisteredUnbuffered
Rank1Rx16
Heat SpreaderNo
Compatible SystemDell OptiPlex 7000 XE Micro
Dell OptiPlex 7010 Micro Plus

Citas šī modeļa versijas

Vēl 5 šajā sērijā

Viena saime, taču atšķirīga atmiņa, dzesētājs vai frekvence — salīdziniet, pirms izlemjat.

Jautājumi par šo preci

How hot does the 1.1 V DDR5 module run during continuous workloads?

The module operates at the standard 1.1 V DDR5 voltage with no heat spreader, so thermals depend on the OptiPlex 7000 XE Micro or 7010 Micro Plus chassis airflow.

What is the sustained power draw of the 8 GB CL40 SODIMM under load?

At 1.1 V the 1Rx16 DDR5 4800 module draws only a few watts; the OptiPlex Micro power supply handles it without extra connectors.

Which slot keying must the OptiPlex 7000 XE Micro or 7010 Micro Plus provide for this 262-pin SODIMM?

The system needs a standard DDR5 262-pin SODIMM slot; the module is a direct replacement for Dell part numbers AB949333 and SNPMVK8PC/8G.

Arī šajā sadaļā

Klienti arī salīdzināja

Tas pats plaukts, tā pati kase — astoņas kriptovalūtas un kursa fiksēšana uz 30 minūtēm.