Prihvaćamo kriptovalute — tako kriptovalute koje posjedujete mogu kupiti pravi hardver.Plaćajte kriptovalutom, trošite je na pravi hardver. Besplatna osigurana dostava diljem svijeta iznad 399 $. Obični vanjski kartoni bez oznaka, otpremaju se iz Njemačke.Besplatna osigurana dostava iznad 399 $. Vaš je tečaj blokiran 30 minuta od otvaranja blagajne.Tečaj blokiran 30 minuta. Svaki je artikl zapečaćen, njegov serijski broj provjeren, i pokriven jamstvom od 24 mjeseca.Zapečaćen, jamstvo 24 mjeseca.

Praćeni artikli Prijava
Green circuit board with black memory chips 262-pin SODIMM

OWC

OWC 8GB DDR5 4800 CL40 262-pin SODIMM memory upgrade for OptiPlex 7000 XE Micro 7010 Micro Plus

SKU CH-ZQXW-G6EET

8 GB DDR5-4800 SODIMM module for OptiPlex 7000 XE Micro and 7010 Micro Plus

  • Capacity8GB
  • Type262-Pin DDR5 Non-ECC SODIMM
  • SpeedDDR5 4800 (PC5 38400)
  • CAS LatencyCL40
  • Voltage1.1V
  • ECCNo
  • 8GB DDR5 4800 MHz boosts multitasking responsiveness
  • CL40 latency at 1.1V lowers power draw
  • 262-pin SODIMM fits OptiPlex 7000 XE Micro and 7010 Micro Plus
  • JEDEC and RoHS compliant for warranty-safe upgrades
  • Replaces Dell part numbers AB949333 SNPMVK8PC/8G

8GB DDR5 4800 SODIMM for OptiPlex Micro

This OWC module adds 8GB of DDR5 memory to compatible Dell OptiPlex systems. It runs at 4800 MT/s with CL40 latency at 1.1V. The 262-pin SODIMM fits the 7000 XE Micro and 7010 Micro Plus. It is an unbuffered, non-ECC 1Rx16 design without a heat spreader.

Suits single-slot upgrades on supported OptiPlex

Builders expanding a 7000 XE Micro or 7010 Micro Plus with one module will find this part validated for those chassis. Systems requiring ECC, registered DIMMs, or a different pin count cannot use this module. Buyers needing higher capacity per slot or a dual-rank configuration should look at other options.

4800 MT/s JEDEC speed with CL40 timing

The module operates at the standard DDR5 4800 data rate (PC5-38400) with a CAS latency of 40 cycles. This speed and timing are fixed by the JEDEC profile on the SPD. No higher frequency or tighter latency is programmed on this stick.

Istaknuto

  • 8GB DDR5 4800 MHz boosts multitasking responsiveness
  • CL40 latency at 1.1V lowers power draw
  • 262-pin SODIMM fits OptiPlex 7000 XE Micro and 7010 Micro Plus
  • JEDEC and RoHS compliant for warranty-safe upgrades
  • Replaces Dell part numbers AB949333 SNPMVK8PC/8G

Specifikacije

BrandOWC
Part Number4S8D51R608GB
Capacity8GB
Type262-Pin DDR5 Non-ECC SODIMM
SpeedDDR5 4800 (PC5 38400)
CAS LatencyCL40
Voltage1.1V
ECCNo
Buffered/RegisteredUnbuffered
Rank1Rx16
Heat SpreaderNo
Compatible SystemDell OptiPlex 7000 XE Micro
Dell OptiPlex 7010 Micro Plus

Druge verzije ovog modela

još 5 u istoj seriji

Ista obitelj, različita memorija, hladnjak ili frekvencija — usporedite prije kupnje.

Pitanja o ovom artiklu

How hot does the 1.1 V DDR5 module run during continuous workloads?

The module operates at the standard 1.1 V DDR5 voltage with no heat spreader, so thermals depend on the OptiPlex 7000 XE Micro or 7010 Micro Plus chassis airflow.

What is the sustained power draw of the 8 GB CL40 SODIMM under load?

At 1.1 V the 1Rx16 DDR5 4800 module draws only a few watts; the OptiPlex Micro power supply handles it without extra connectors.

Which slot keying must the OptiPlex 7000 XE Micro or 7010 Micro Plus provide for this 262-pin SODIMM?

The system needs a standard DDR5 262-pin SODIMM slot; the module is a direct replacement for Dell part numbers AB949333 and SNPMVK8PC/8G.

Također u ovoj kategoriji

Kupci su usporedili ovo

Ista polica, ista blagajna — osam valuta i blokada tečaja na 30 minuta.