Mēs pieņemam kriptovalūtu — lai tā, kas Jums pieder, varētu nopirkt īstu aparatūru.Maksājiet kriptovalūtā, iztērējiet to īstai aparatūrai. Bezmaksas apdrošināta piegāde visā pasaulē virs 399 $. Vienkāršas, nemarķētas kastes, sūtītas no Vācijas.Bezmaksas apdrošināta piegāde virs 399 $. Jūsu kurss tiek fiksēts uz 30 minūtēm, tiklīdz atveras kase.Kurss fiksēts uz 30 minūtēm. Katra prece ir aizzīmogota, tās sērijas numurs ir pārbaudīts, un uz to attiecas 24 mēnešu garantija.Aizzīmogots, 24 mēnešu garantija.

Uzraudzītās preces Pieteikties

Timetec

Timetec 35TTFP6PCIE-1TB 1TB M.2 2280 internal SSD

SKU CH-WAAC-DFYP7

M.2 2280 NVMe SSD with 1TB 3D TLC NAND, PCIe 3.0 x4, up to 2000/1600 MB/s, 600 TBW and 1,500,000-hour MTBF

  • Device TypeInternal Solid State Drive (SSD)
  • Used ForConsumer
  • Form FactorM.2 2280
  • Capacity1TB
  • Memory Components3D TLC NAND
  • InterfacePCI-Express 3.0 x4
  • Up to 2000 MB/s read speed for quick boot times
  • Up to 1600 MB/s write speed for fast file transfers
  • 600 TBW endurance rating for long-term reliability
  • 5 million hours MTBF for dependable operation
  • M.2 2280 form factor fits laptops and desktops

1TB M.2 2280 NVMe SSD

The Timetec 35TTFP6PCIE-1TB is a 1TB internal solid-state drive built on 3D TLC NAND. It connects through a PCI-Express 3.0 x4 lane and speaks the NVMe 1.3 protocol. The drive fits laptops, desktops and compact PCs that accept an M.2 2280 NVMe module.

Thermals and power in daily use

Rated sequential throughput reaches 2000 MBps read and 1600 MBps write, with SLC cache boosting burst workloads. The controller supports APST and ASPM power management, keeping consumption low during idle and light loads. An MTBF of 1500000 hours and 600TB TBW indicate sustained reliability without active cooling.

Build integration notes

The single-sided 22x80mm board slides into any M.2 2280 key-M slot, leaving adjacent headers and expansion cards unobstructed. Backward compatibility with PCIe Gen 2 and Gen 1 platforms means the same drive works in older systems. No cables, screws or brackets are included, so the builder supplies the motherboard standoff and fastener.

Priekšrocības

  • Up to 2000 MB/s read speed for quick boot times
  • Up to 1600 MB/s write speed for fast file transfers
  • 600 TBW endurance rating for long-term reliability
  • 5 million hours MTBF for dependable operation
  • M.2 2280 form factor fits laptops and desktops

Specifikācijas

BrandTimetec
Part Number35TTFP6PCIE-1TB
Device TypeInternal Solid State Drive (SSD)
Used ForConsumer
Form FactorM.2 2280
Capacity1TB
Memory Components3D TLC NAND
InterfacePCI-Express 3.0 x4
Max Sequential ReadUp to 2000 MBps
Max Sequential WriteUp to 1600 MBps
Terabytes Written (TBW)600TB

Citas šī modeļa versijas

Vēl 5 šajā sērijā

Viena saime, taču atšķirīga atmiņa, dzesētājs vai frekvence — salīdziniet, pirms izlemjat.

Jautājumi par šo preci

How is the M.2 2280 drive installed and what step is often missed?

Insert the drive into the M.2 slot at an angle, press it flat and fasten the single mounting screw; the step often missed is confirming the motherboard standoff is positioned for the 2280 length before inserting the drive.

What maintenance or replacement will the 1 TB 3D TLC NAND drive need later?

No scheduled maintenance is required; the drive uses wear-levelling, TRIM and ECC to manage the 3D TLC NAND, and replacement is only needed once the 600 TBW endurance rating is exceeded or if the SMART health status reports a critical warning.

What limit appears first during sustained writes on this PCIe 3.0 x4 SSD?

The SLC cache fills after a large sequential write burst, causing write speeds to drop from the peak 1600 MB/s toward the native 3D TLC NAND rate; thermal throttling may then engage if the controller temperature rises under continued load.

Arī šajā sadaļā

Klienti arī salīdzināja

Tas pats plaukts, tā pati kase — astoņas kriptovalūtas un kursa fiksēšana uz 30 minūtēm.