Timetec
Timetec 35TTFP6PCIE-1TB 1TB M.2 2280 internal SSD
M.2 2280 NVMe SSD with 1TB 3D TLC NAND, PCIe 3.0 x4, up to 2000/1600 MB/s, 600 TBW and 1,500,000-hour MTBF
- Device TypeInternal Solid State Drive (SSD)
- Used ForConsumer
- Form FactorM.2 2280
- Capacity1TB
- Memory Components3D TLC NAND
- InterfacePCI-Express 3.0 x4
Options 1TB (1 Pack)
- Up to 2000 MB/s read speed for quick boot times
- Up to 1600 MB/s write speed for fast file transfers
- 600 TBW endurance rating for long-term reliability
- 5 million hours MTBF for dependable operation
- M.2 2280 form factor fits laptops and desktops
1TB M.2 2280 NVMe SSD
The Timetec 35TTFP6PCIE-1TB is a 1TB internal solid-state drive built on 3D TLC NAND. It connects through a PCI-Express 3.0 x4 lane and speaks the NVMe 1.3 protocol. The drive fits laptops, desktops and compact PCs that accept an M.2 2280 NVMe module.
Thermals and power in daily use
Rated sequential throughput reaches 2000 MBps read and 1600 MBps write, with SLC cache boosting burst workloads. The controller supports APST and ASPM power management, keeping consumption low during idle and light loads. An MTBF of 1500000 hours and 600TB TBW indicate sustained reliability without active cooling.
Build integration notes
The single-sided 22x80mm board slides into any M.2 2280 key-M slot, leaving adjacent headers and expansion cards unobstructed. Backward compatibility with PCIe Gen 2 and Gen 1 platforms means the same drive works in older systems. No cables, screws or brackets are included, so the builder supplies the motherboard standoff and fastener.
Põhijooned
- Up to 2000 MB/s read speed for quick boot times
- Up to 1600 MB/s write speed for fast file transfers
- 600 TBW endurance rating for long-term reliability
- 5 million hours MTBF for dependable operation
- M.2 2280 form factor fits laptops and desktops
Tehnilised andmed
| Brand | Timetec |
|---|---|
| Part Number | 35TTFP6PCIE-1TB |
| Device Type | Internal Solid State Drive (SSD) |
| Used For | Consumer |
| Form Factor | M.2 2280 |
| Capacity | 1TB |
| Memory Components | 3D TLC NAND |
| Interface | PCI-Express 3.0 x4 |
| Max Sequential Read | Up to 2000 MBps |
| Max Sequential Write | Up to 1600 MBps |
| Terabytes Written (TBW) | 600TB |
Selle mudeli teised versioonid
5 veel samast sarjast
Sama seeria, erinev mälumaht, jahutus või taktsagedus — võrrelge enne otsustamist.
Timetec 512GB NVMe M.2 2280 internal SSD
- Up to 2000 MBps
- Up to 1600 MBps
Timetec 1TB x10 NVMe PCIe 3.0 M.2 2280 internal SSD
- Internal Solid Stat…
- Consumer
Küsimused selle toote kohta
How is the M.2 2280 drive installed and what step is often missed?
Insert the drive into the M.2 slot at an angle, press it flat and fasten the single mounting screw; the step often missed is confirming the motherboard standoff is positioned for the 2280 length before inserting the drive.
What maintenance or replacement will the 1 TB 3D TLC NAND drive need later?
No scheduled maintenance is required; the drive uses wear-levelling, TRIM and ECC to manage the 3D TLC NAND, and replacement is only needed once the 600 TBW endurance rating is exceeded or if the SMART health status reports a critical warning.
What limit appears first during sustained writes on this PCIe 3.0 x4 SSD?
The SLC cache fills after a large sequential write burst, causing write speeds to drop from the peak 1600 MB/s toward the native 3D TLC NAND rate; thermal throttling may then engage if the controller temperature rises under continued load.
Veel samast osakonnast
Kliendid võrdlesid neid ka
Sama osakond, sama kassa — kaheksa krüptovaluutat ja 30-minutiline kursilukk.








