EN-Labs 11-001-366 PCIe x4 USB 3.2 10Gbps 5-port card
- no
- 12CM Case fan,screw…
Kami menerima kripto — jadi koin yang anda simpan boleh membeli perkakasan sebenar.Bayar dengan kripto, belanjakannya untuk perkakasan sebenar. Penghantaran berinsurans percuma ke seluruh dunia untuk belian melebihi USD 399. Kotak biasa tanpa jenama, dihantar dari Jerman.Penghantaran berinsurans percuma untuk belian melebihi USD 399. Kadar anda dikunci selama 30 minit sebaik sahaja proses pesanan bermula.Kadar dikunci selama 30 minit. Setiap item disegel, nombor sirinya disemak, dan dilindungi waranti 24 bulan.Disegel, waranti 24 bulan.
A-Tech
A 16GB DDR4 2133MHz CL15 unbuffered DIMM certified for Supermicro systems, using Hynix chips at 1.2V standard voltage
This A-Tech module delivers 16GB of DDR4 memory at 2133MHz with a CL15 latency. It is an unbuffered, non-ECC DIMM built on a Hynix chipset and certified for Supermicro systems. The 288-pin form factor fits standard desktop motherboards that support DDR4 memory.
Replacing an 8GB stick or a slower DDR4 kit with this 16GB module doubles capacity and restores rated 2133MHz speed. The jump is worth it when your workload exceeds current memory limits or when a qualified vendor list requires this specific Supermicro certified part number.
Installation follows the standard 288-pin DIMM procedure: align the notch, press firmly until the retention clips engage, and verify seating. The most common issue is a mismatch between the module specifications and the motherboard qualified vendor list, so confirm supported speeds and capacities before purchase.
| Brand | SuperMicro |
|---|---|
| Series | Supermicro Certified |
| Model | MEM-DR416L-HL01-UN21 |
| Capacity | 16GB |
| Speed | DDR4 2133 (PC4 17000) |
| Tested Frequency | 2133 |
| CAS Latency | CL15 |
| Voltage | 1.20V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Chipset | Major Brand Chipset |
| Heat Spreader | No |
| Features | Supermicro Certified MEM-DR416L-HL01-UN21 (HMA82GU6MFR8N-TF) |
| Recommend Use | Compatible Supermicro Systems |
This module uses the standard 288-pin DDR4 DIMM form factor, so it fits any desktop board with DDR4 slots.
Align the off-centre notch with the key in the slot, press straight down until the side clips click shut on both ends.
The module is built with Hynix chips and carries a lifetime warranty, so under normal desktop use it should not require replacement.
Juga di rak ini
Rak yang sama, checkout yang sama — lapan koin kripto dan kunci kadar 30 minit.
Apa yang anda hantar untuk membayar, dan mata wang yang anda guna untuk membaca harga.
Dihantar daripada dompet anda semasa semak keluar
Untuk paparan sahaja — katalog diberi harga dalam USD
Tiada mata wang yang sepadan.
Pilih bahasa yang digunakan oleh laman web ini.
Pengguna baharu?
Sudah mempunyai akaun?
Tiada set semula automatik: kedai ini tidak menghantar sebarang e-mel, jadi tiada pautan sekali guna untuk diminta. Biarkan alamat pada akaun tersebut, ia akan diuruskan secara manual.
Permintaan direkodkan
Tiada apa-apa akan sampai ke peti masuk anda — kedai ini tidak menghantar sebarang e-mel. Seseorang akan menguruskannya secara manual.
Sudah teringat?