Computer Memory Solutions
Computer Memory Solutions 16GB (4 x 4GB) DDR2 667 ECC Registered 240-Pin for Dell PowerEdge 2850
Four-module kit adds 16 GB of DDR2-667 ECC registered memory to a Dell PowerEdge 2850 server
- Capacity16GB (4 x 4GB)
- Type240-Pin DDR2 SDRAM
- SpeedDDR2 667 (PC2 5300)
- CAS LatencyCL5
- Timing5-5-5
- Voltage1.8V
- 16 GB kit expands Dell PowerEdge 2850 capacity
- ECC registered DDR2 protects server data integrity
- Four matched 4 GB modules enable dual-channel performance
- 667 MHz CL5 timing meets system specifications
- 8 V 240-pin DIMMs install directly in server slots
Dell PowerEdge 2850 server memory kit
This 16GB kit contains four 4GB DDR2 registered ECC modules built for the Dell PowerEdge 2850. Each stick runs at 667 MHz with CL5 timing at 1.8V. The 240-pin DIMMs use a 2Rx4 organisation and are validated for the server’s six-slot architecture.
Sustained load behaviour with registered ECC
Registered buffering reduces electrical load on the memory controller when all six sockets are populated. ECC corrects single-bit errors in real time, preventing silent data corruption during long compute runs. The dual-rank layout lets the chipset interleave accesses across ranks for steadier throughput under continuous demand.
Upgrading from smaller or non-ECC configurations
Replacing a partial kit or non-ECC memory with this matched set reaches the platform’s 16GB ceiling and enables the full eight-rank limit the chipset supports. The jump is worthwhile when workloads need maximum capacity with error correction rather than raw speed. Builders needing higher frequencies or larger single modules must choose a newer platform.
Ciri-ciri utama
- 16 GB kit expands Dell PowerEdge 2850 capacity
- ECC registered DDR2 protects server data integrity
- Four matched 4 GB modules enable dual-channel performance
- 667 MHz CL5 timing meets system specifications
- 8 V 240-pin DIMMs install directly in server slots
Spesifikasi
| Brand | Computer Memory Solutions |
|---|---|
| Model | CM512725300ECCREG2R4 |
| Capacity | 16GB (4 x 4GB) |
| Type | 240-Pin DDR2 SDRAM |
| Speed | DDR2 667 (PC2 5300) |
| CAS Latency | CL5 |
| Timing | 5-5-5 |
| Voltage | 1.8V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 2Rx4 |
| Chipset | Major Brand Chipset |
| Heat Spreader | Based on Current Inventory (If Required Please Contact) |
| Compatible System | Dell Poweredge 2850 |
| Package Content | 1 Memory RAM Stick |
Soalan tentang produk ini
How much power does the DDR2-667 registered ECC kit draw at its rated 1.8 V when running continuously?
Each module operates at 1.8 V, the standard voltage for DDR2-667 registered ECC DIMMs.
Does the Dell PowerEdge 2850 require any specific firmware version or BIOS setting to recognise these four 4 GB registered DIMMs?
The kit is guaranteed compatible with the PowerEdge 2850; the first DIMM may be populated singly and additional memory must be added in pairs.
Can I mix these 2Rx4 registered ECC modules with older single-rank DDR2 DIMMs already installed in the same server?
The chipset supports a maximum of eight ranks, so mixing is possible within that limit, but all modules must be registered ECC DDR2.
Juga di rak ini
Pelanggan turut membandingkan
Rak yang sama, checkout yang sama — lapan koin kripto dan kunci kadar 30 minit.



