OEM Industries
OEM Industries FFB0812EHH 80mm 12V 1.35A 3-Wire CPU Cooler
An 80 mm 12 V 1.35 A ball-bearing fan with a 3-wire connector for CPU cooling
- ColorBlack
- TypeFan only
- Fan Size80mm
- Bearing TypeBall
- Power Connector3 Wires
- LEDNo
- Efficient brushless motor runs at 12V with 1.35A draw
- 80mm frame fits tight builds while delivering strong airflow
- Ball bearing design extends service life under continuous load
- Three-wire connector enables speed monitoring and PWM control
- Delta 8038 platform proven in industrial cooling applications
80 mm 12 V 3-wire fan
The OEM Industries FFB0812EHH is an 80 mm DC brushless cooler that runs on 12 V and draws 1.35 A through a standard three-wire connector. It uses a ball-bearing motor and has no LED lighting. The unit is supplied new and is intended as a direct replacement or upgrade for compatible CPU air-cooling assemblies.
Builders needing a compact 80 mm replacement
This cooler suits technicians servicing legacy or space-constrained systems that specify an 80 mm 12 V fan with a three-wire power lead. It is not suitable for builds that require PWM speed control, larger fan diameters, RGB illumination or higher airflow ratings than the unit provides.
Single-fan capacity and limits
The 80 mm frame and 1.35 A current draw give enough airflow for low-to-moderate thermal loads in tight chassis. It will run out of headroom on high-TDP processors or in cases with restricted ventilation where a larger or higher-static-pressure fan would be needed.
Ciri-ciri utama
- Efficient brushless motor runs at 12V with 1.35A draw
- 80mm frame fits tight builds while delivering strong airflow
- Ball bearing design extends service life under continuous load
- Three-wire connector enables speed monitoring and PWM control
- Delta 8038 platform proven in industrial cooling applications
Spesifikasi
| Model | FFB0812EHH |
|---|---|
| Color | Black |
| Type | Fan only |
| Fan Size | 80mm |
| Bearing Type | Ball |
| Power Connector | 3 Wires |
| LED | No |
Soalan tentang produk ini
Does the FFB0812EHH need a 3-pin fan header on the motherboard to run?
Yes, it uses a 3-wire power connector that plugs directly into a standard 3-pin fan header for 12 V supply and speed reporting.
Will the 80 mm frame fit the mounting holes of an older Delta 8038 cooler?
The 80 mm square frame matches the 8038 footprint, so the same four mounting holes line up without an adapter bracket.
How can I confirm the ball-bearing fan is spinning at the rated 1.35 A after installation?
Check the motherboard hardware monitor or fan-control software; it should report a steady RPM and a current draw close to 1.35 A on the 12 V rail.
Juga di rak ini
Pelanggan turut membandingkan
Rak yang sama, checkout yang sama — lapan koin kripto dan kunci kadar 30 minit.
ModMyMods MOD-0002 3/8" ID x 1/2" OD Clear PVC Tubing DIY Cooling
- Clear



