OWC 4GB DDR3 1600 CL11 1Rx8 240-pin 1.5V Non-ECC UDIMM for Dell OptiPlex 9010
- 4GB
- 240-Pin DDR3 Non-EC…
Kami menerima kripto — jadi koin yang anda simpan boleh membeli perkakasan sebenar.Bayar dengan kripto, belanjakannya untuk perkakasan sebenar. Penghantaran berinsurans percuma ke seluruh dunia untuk belian melebihi USD 399. Kotak biasa tanpa jenama, dihantar dari Jerman.Penghantaran berinsurans percuma untuk belian melebihi USD 399. Kadar anda dikunci selama 30 minit sebaik sahaja proses pesanan bermula.Kadar dikunci selama 30 minit. Setiap item disegel, nombor sirinya disemak, dan dilindungi waranti 24 bulan.Disegel, waranti 24 bulan.
OWC
A 4 GB DDR3L SODIMM module running at 1600 MHz with CL11 latency and 1.35 V operation for HP 15 series notebooks
This 4GB SODIMM is built for HP 15 Series laptops that use DDR3 memory. It suits owners who want a straightforward capacity increase without replacing the entire system. The module matches the factory voltage and timing so the notebook recognises it immediately. Buyers needing ECC or registered memory should look elsewhere.
The stick meets JEDEC PC3L-12800 CL11 specifications and is RoHS compliant, which keeps the upgrade warranty-safe for the laptop. No extra software, drivers or heat spreaders are bundled in the package. The single rank 1Rx8 organisation follows the original equipment layout. Systems that require buffered or ECC modules will not accept this part.
Installation means opening the memory door, aligning the 204-pin key, and pressing until the clips latch. Most users complete the swap in a few minutes with no tools beyond a small screwdriver. The only common issue is seating the module fully so both retention clips engage. OWC provides an online video that demonstrates the procedure step by step.
| Brand | OWC |
|---|---|
| Part Number | 1S6T31R804GB |
| Capacity | 4GB |
| Type | 204-Pin DDR3L Non-ECC SODIMM |
| Speed | DDR3L 1600 (PC3L 12800) |
| CAS Latency | CL11 |
| Voltage | 1.35V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Rank | 1Rx8 |
| Heat Spreader | No |
| Compatible System | HP 15 Series using DDR3 Memory |
Versi lain model ini
Keluarga yang sama, memori, penyejuk atau kelajuan jam yang berbeza — bandingkan sebelum membuat keputusan.
The module is an unbuffered 1Rx8 DDR3L SODIMM; no firmware update is required, but matching capacity, speed and manufacturer is recommended for best stability.
The rated PC3L-12800 bandwidth and CL11 latency are fixed by the JEDEC profile; sustained use will hit the bandwidth ceiling before latency becomes a bottleneck.
Operating at 1.35 V without a heat spreader, the module draws minimal power and stays cool enough for continuous operation in the HP 15 chassis.
Juga di rak ini
Rak yang sama, checkout yang sama — lapan koin kripto dan kunci kadar 30 minit.
Apa yang anda hantar untuk membayar, dan mata wang yang anda guna untuk membaca harga.
Dihantar daripada dompet anda semasa semak keluar
Untuk paparan sahaja — katalog diberi harga dalam USD
Tiada mata wang yang sepadan.
Pilih bahasa yang digunakan oleh laman web ini.
Tiada bahasa yang sepadan.
Pengguna baharu?
Sudah mempunyai akaun?
Tiada set semula automatik: kedai ini tidak menghantar sebarang e-mel, jadi tiada pautan sekali guna untuk diminta. Biarkan alamat pada akaun tersebut, ia akan diuruskan secara manual.
Permintaan direkodkan
Tiada apa-apa akan sampai ke peti masuk anda — kedai ini tidak menghantar sebarang e-mel. Seseorang akan menguruskannya secara manual.
Sudah teringat?