NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Vi tar imot kryptovaluta — slik kan kryptovalutaene du eier, kjøpe ekte maskinvare.Betal med krypto, bruk den på ekte maskinvare. Gratis, forsikret levering verden over for bestillinger over 399 $. Nøytrale kartonger uten merking, sendt fra Tyskland.Gratis, forsikret levering over 399 $. Kursen din er låst i 30 minutter når kassen åpnes.Kurs låst i 30 minutter. Alle varer er forseglet, serienummerkontrollert og dekket av 24 måneders garanti.Forseglet, 24 måneders garanti.
A-Tech
A 64 GB dual-channel kit of DDR4 3200 MHz ECC UDIMM modules with CL22 latency and 1.2 V operation for servers and workstations
This 64 GB kit contains two 32 GB DDR4 3200 MHz ECC UDIMM modules built for servers and workstations that require error-correcting unbuffered memory. It is not compatible with standard desktop or laptop computers. Each module uses a 288-pin DIMM form factor and operates at the standard 1.2 V DDR4 voltage. The dual-rank 2Rx8 organisation helps increase memory density for demanding workloads.
The modules run at DDR4 3200 MHz with a CAS latency of CL22, which sets the practical speed limit for this memory standard. Systems that only support lower DDR4 frequencies will downclock the kit automatically. The ECC unbuffered design adds error correction overhead but does not change the fundamental bandwidth ceiling of the DDR4 3200 interface. Mixing these modules with different speeds or ranks can further restrict achievable performance.
Installation follows the usual DIMM slot procedure: align the notch, press firmly until the retention clips click, and follow the motherboard manual for correct channel population. The most common issue is incomplete seating, which causes the system to recognise less memory or fail to boot. Because this is ECC unbuffered memory, the platform must explicitly support that type; otherwise the modules will not function even if they physically fit.
| CAS Latency | CL22 |
|---|---|
| Rank | 2Rx8 |
The kit provides 64 GB total using two 32 GB modules. Select this capacity if your workload and motherboard slot count can use the full amount; otherwise a smaller kit leaves room for future expansion.
The modules run at DDR4 3200 MHz with CL22 latency at the standard 1.2 V, delivering the rated throughput when the platform supports that speed and the memory controller is configured accordingly.
It uses the 288-pin DDR4 UDIMM form factor with ECC unbuffered signalling, so it fits standard DDR4 server and workstation slots that explicitly support ECC UDIMM; desktop or laptop boards that lack ECC support will not work.
Også i denne avdelingen
Samme hylle, samme kasse — åtte mynter og 30 minutters kurslås.
Det du betaler med, og det du ser prisene i.
Sendes fra lommeboken din i kassen
Kun visning — katalogen er prissatt i USD
Fant ingen valuta.
Velg språket nettstedet snakker til deg på.
Ny her?
Har du allerede en konto?
Det finnes ingen automatisk tilbakestilling: butikken sender ikke e-post, så det finnes ingen engangslenke å be om. La adressen stå på kontoen, så blir den behandlet manuelt.
Forespørsel registrert
Ingenting er på vei til innboksen din — butikken sender ingen e-post i det hele tatt. Noen behandler dette manuelt.
Husket du det likevel?