Vi tar imot kryptovaluta — slik kan kryptovalutaene du eier, kjøpe ekte maskinvare.Betal med krypto, bruk den på ekte maskinvare. Gratis, forsikret levering verden over for bestillinger over 399 $. Nøytrale kartonger uten merking, sendt fra Tyskland.Gratis, forsikret levering over 399 $. Kursen din er låst i 30 minutter når kassen åpnes.Kurs låst i 30 minutter. Alle varer er forseglet, serienummerkontrollert og dekket av 24 måneders garanti.Forseglet, 24 måneders garanti.

Overvåkingsliste Logg inn
Ten yellow copper power cables with 6+2 pin and 6 pin connectors, 42cm long

AFRNDK

AFRNDK Miner Cable 6+2P 6P 12AWG 18AWG 8Pin 42cm Yellow 10PCS

SKU CH-BDC9-7E8JX

Pack of ten yellow copper cables with 6+2 pin and 6 pin connectors in 12AWG and 18AWG gauges for Antminer L3+ L3++ S9 S9i

  • CPU TypeAMD APU
  • Copper conductors ensure efficient power delivery for mining rigs
  • Yellow insulation allows quick cable identification in dense setups
  • 10 cables per pack supply multiple GPU or ASIC connections
  • Mixed 12AWG and 18AWG wires handle both primary and auxiliary power needs
  • 42cm length fits compact miner chassis without excess slack

Miner cable 6+2P and 6P for Antminer L3+ L3++ S9 S9i

This lot contains ten yellow power cables built with copper wire in 12AWG and 18AWG gauges. Each lead measures 42 centimetres and terminates in an 8-pin connector suitable for the listed Antminer models. The cables are new and intended for crypto mining rigs.

Suits miners replacing worn leads on supported

Builders who need a different pin layout, a longer reach or a higher gauge should look at other options. The fixed 42 centimetre length may not fit larger chassis or custom frame designs. Buyers running hardware outside the L3+ L3++ S9 S9i range cannot use these leads.

42 centimetre length decides fit in your frame

Measure the distance from your power supply to the board before ordering. If the run exceeds 42 centimetres these cables will not reach. The 12AWG and 18AWG copper conductors are sized for the supported Antminer models only.

Høydepunkter

  • Copper conductors ensure efficient power delivery for mining rigs
  • Yellow insulation allows quick cable identification in dense setups
  • 10 cables per pack supply multiple GPU or ASIC connections
  • Mixed 12AWG and 18AWG wires handle both primary and auxiliary power needs
  • 42cm length fits compact miner chassis without excess slack

Spesifikasjoner

CPU TypeAMD APU

Spørsmål om denne varen

What power connectors must my PSU already provide to use these 6+2 pin cables?

Your PSU needs free 6-pin PCIe connectors because each cable plugs into a 6-pin source and splits to an 8-pin 6+2 end for the miner.

Will these 12 AWG and 18 AWG wires handle the same current as the original Antminer S9 loom?

The mixed 12 AWG and 18 AWG copper conductors match the gauge combination used in the stock harness for L3+, L3++, S9 and S9i units.

How can I confirm every cable is seated correctly after routing the 42 cm yellow leads?

Check that each 8-pin 6+2 connector clicks fully into the hash board and that the yellow insulation shows no kinks along the 42 cm run.

Også i denne avdelingen

Kunder sammenlignet disse

Samme hylle, samme kasse — åtte mynter og 30 minutters kurslås.