Vi tar imot kryptovaluta — slik kan kryptovalutaene du eier, kjøpe ekte maskinvare.Betal med krypto, bruk den på ekte maskinvare. Gratis, forsikret levering verden over for bestillinger over 399 $. Nøytrale kartonger uten merking, sendt fra Tyskland.Gratis, forsikret levering over 399 $. Kursen din er låst i 30 minutter når kassen åpnes.Kurs låst i 30 minutter. Alle varer er forseglet, serienummerkontrollert og dekket av 24 måneders garanti.Forseglet, 24 måneders garanti.

Overvåkingsliste Logg inn
Rectangular black ATX power supply with 4-pin connector and cooling vents

godream

godream Power Supply 4Pin 180W PA-1181-6HY

SKU CH-M6JZ-NHSJ7

180 W ATX power supply with 4-pin connector for HP ProDesk MT and SFF models 86, 89, 280, 282, 285, 288, 390, 400, 480, 600 and 800

  • TypeATX
  • Compatible with HP ProDesk 86 89 480 400 G4 280 282 285 288 600 800 G3 G1 G2 MT 390 SFF
  • 4-pin connector matches PA-1181-6HY for direct replacement
  • 180 W output powers supported desktops reliably
  • ATX form factor fits standard chassis layouts

Compatible HP ProDesk models

This 180 watt ATX power supply replaces the PA-1181-6HY unit in HP ProDesk 86, 89, 280, 282, 285, 288, 390, 400, 480, 600 and 800 small form factor and micro tower desktops. It uses the proprietary four pin connector required by these chassis. Builders working on other platforms or needing higher output should look elsewhere.

Thermals noise and power draw

The unit delivers up to 180 watts through a standard ATX topology with a single four pin motherboard connection. In normal office workloads the internal fan runs at low speed and stays quiet. Under sustained load the fan ramps up to maintain safe temperatures while drawing no more than the rated 180 watts from the wall.

Høydepunkter

  • Compatible with HP ProDesk 86 89 480 400 G4 280 282 285 288 600 800 G3 G1 G2 MT 390 SFF
  • 4-pin connector matches PA-1181-6HY for direct replacement
  • 180 W output powers supported desktops reliably
  • ATX form factor fits standard chassis layouts

Spesifikasjoner

TypeATX

Spørsmål om denne varen

How do I install the 4-pin PA-1181-6HY power supply in an HP ProDesk 400 G4 MT and which step is most often missed?

Remove the side panel, unplug the old unit, slide the new supply into the chassis, secure it with the rear screws, then reconnect the 24-pin motherboard and 4-pin CPU power cables; the step most often missed is seating the 4-pin CPU connector fully until it clicks

What maintenance will the 180 W PA-1181-6HY unit need during its service life?

Clean the intake and exhaust grilles with compressed air every few months to keep airflow clear; the unit has no user-replaceable parts, so if the fan becomes noisy or voltages drift, replace the entire power supply

Også i denne avdelingen

Kunder sammenlignet disse

Samme hylle, samme kasse — åtte mynter og 30 minutters kurslås.