NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Vi tar imot kryptovaluta — slik kan kryptovalutaene du eier, kjøpe ekte maskinvare.Betal med krypto, bruk den på ekte maskinvare. Gratis, forsikret levering verden over for bestillinger over 399 $. Nøytrale kartonger uten merking, sendt fra Tyskland.Gratis, forsikret levering over 399 $. Kursen din er låst i 30 minutter når kassen åpnes.Kurs låst i 30 minutter. Alle varer er forseglet, serienummerkontrollert og dekket av 24 måneders garanti.Forseglet, 24 måneders garanti.
KHACHIMO
Delivers 2000 W of 80 PLUS Gold ATX power with zero-RPM fan mode and Modern Standby support
The KHACHIMO NCS1K-2KW-AC is a 2000 watt ATX power supply built for systems that demand high continuous output. It carries 80 PLUS Gold certification for efficient power delivery and lower heat. Resonant LLC topology with DC-to-DC conversion provides clean, stable voltage rails. Modern Standby compatibility enables rapid wake-from-sleep transitions.
This unit suits builders assembling high-power workstations or servers that can use a 2000 watt ATX supply. The Zero RPM fan mode keeps acoustics low at light loads by stopping the fan completely. Buyers whose builds require less power or who are limited to smaller form-factor cases that cannot accommodate a standard ATX unit should consider other options.
The 80 PLUS Gold rating is the key specification that confirms high efficiency across typical load ranges, reducing wasted energy and operating temperature. This certification, combined with the LLC resonant design, supports the stable output required by demanding multi-GPU or compute configurations. Verify that your chassis and components are compatible with a 2000 watt ATX power supply before purchase.
| Type | ATX |
|---|
It follows the ATX form factor, so it fits standard ATX cases but its 2000W output requires a case with enough clearance for the unit's length and adequate airflow for high-wattage operation.
The unit needs a standard 24-pin ATX motherboard connector, an 8-pin (or 4+4) CPU power connector, and multiple PCIe 6+2-pin connectors for graphics cards, all of which must be present on the motherboard and GPU.
Secure the PSU to the rear of the case with four screws, orient the fan toward a ventilated panel, and remember to flip the external I/O power switch to the "on" position after wiring, otherwise the system will not start.
Også i denne avdelingen
Samme hylle, samme kasse — åtte mynter og 30 minutters kurslås.
Det du betaler med, og det du ser prisene i.
Sendes fra lommeboken din i kassen
Kun visning — katalogen er prissatt i USD
Fant ingen valuta.
Velg språket nettstedet snakker til deg på.
Ny her?
Har du allerede en konto?
Det finnes ingen automatisk tilbakestilling: butikken sender ikke e-post, så det finnes ingen engangslenke å be om. La adressen stå på kontoen, så blir den behandlet manuelt.
Forespørsel registrert
Ingenting er på vei til innboksen din — butikken sender ingen e-post i det hele tatt. Noen behandler dette manuelt.
Husket du det likevel?