NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Vi tar imot kryptovaluta — slik kan kryptovalutaene du eier, kjøpe ekte maskinvare.Betal med krypto, bruk den på ekte maskinvare. Gratis, forsikret levering verden over for bestillinger over 399 $. Nøytrale kartonger uten merking, sendt fra Tyskland.Gratis, forsikret levering over 399 $. Kursen din er låst i 30 minutter når kassen åpnes.Kurs låst i 30 minutter. Alle varer er forseglet, serienummerkontrollert og dekket av 24 måneders garanti.Forseglet, 24 måneders garanti.
KHACHIMO
ATX power supply delivering 48 volts at 30 amps for 1600 watts of output
The KHACHIMO R4830N2 is a 48V 30A unit rated at 1600W built to the ATX form factor. It targets system integrators and enthusiasts assembling high-current workstations or server-grade platforms that demand sustained 48-volt delivery. Buyers needing standard 12V-only ATX power or lower-wattage units for typical desktop builds should look elsewhere.
The defining specification is the 48-volt rail capable of 30 amps continuous output, yielding the 1600W total capacity. This single rail design dictates compatibility; the power supply only suits hardware engineered for 48V input such as certain GPU compute trays, telecom chassis or specialised industrial boards. Systems expecting conventional 12V ATX distribution cannot use this unit.
Mechanical installation follows standard ATX mounting hole spacing so it fits regular chassis bays without adapters. The primary risk is wiring the 48V output to equipment rated for 12V, which causes immediate damage. Verify every load device accepts 48V before connecting and confirm the mainboard or backplane pin-out matches the supply’s connector layout. No software configuration is required.
| Type | ATX |
|---|
The unit can deliver up to 1600 watts from its 48 volt rail at 30 amps, so a system drawing that power on the 48 volt line will run within its rated capacity.
As an ATX supply it fits standard ATX mounting holes and provides the usual motherboard and peripheral connectors, but it only offers a single 48 volt output rather than multiple rails.
It uses the standard ATX footprint, so it will mount in any case with an ATX power-supply bay and the usual four screw holes.
Også i denne avdelingen
Samme hylle, samme kasse — åtte mynter og 30 minutters kurslås.
Det du betaler med, og det du ser prisene i.
Sendes fra lommeboken din i kassen
Kun visning — katalogen er prissatt i USD
Fant ingen valuta.
Velg språket nettstedet snakker til deg på.
Ny her?
Har du allerede en konto?
Det finnes ingen automatisk tilbakestilling: butikken sender ikke e-post, så det finnes ingen engangslenke å be om. La adressen stå på kontoen, så blir den behandlet manuelt.
Forespørsel registrert
Ingenting er på vei til innboksen din — butikken sender ingen e-post i det hele tatt. Noen behandler dette manuelt.
Husket du det likevel?