Vi tar imot kryptovaluta — slik kan kryptovalutaene du eier, kjøpe ekte maskinvare.Betal med krypto, bruk den på ekte maskinvare. Gratis, forsikret levering verden over for bestillinger over 399 $. Nøytrale kartonger uten merking, sendt fra Tyskland.Gratis, forsikret levering over 399 $. Kursen din er låst i 30 minutter når kassen åpnes.Kurs låst i 30 minutter. Alle varer er forseglet, serienummerkontrollert og dekket av 24 måneders garanti.Forseglet, 24 måneders garanti.

Overvåkingsliste Logg inn
Green DDR5 RDIMM circuit board with black memory chips and gold edge connector

NEMIX RAM

NEMIX RAM 16GB DDR5 4800 CL40 1Rx8 1.1V ECC RDIMM Supermicro H13SSH memory upgrade

SKU CH-AWMP-XZE9M

16 GB DDR5 ECC registered RDIMM running at 4800 MHz with CL40 latency and 1.1 V for the Supermicro H13SSH motherboard

  • Capacity16GB
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 4800 (PC5 38400)
  • CAS LatencyCL40
  • Voltage1.10V
  • ECCYes

Size 16GB

Vis 30 flere konfigurasjoner
  • Exact-match DDR5-4800 16 GB CL40 1Rx8 ECC RDIMM for Supermicro H13SSH
  • 288-pin registered form factor fits the board's required slot type
  • ECC and registered design corrects single-bit errors and stabilises full-population loads
  • 1 V operation matches the platform's native memory voltage spec
  • Lifetime replacement warranty with US-based technical support included

Exact-match DDR5-4800 RDIMM for Supermicro H13SSH

This 16 GB DDR5 4800 (PC5-38400) module is built as a 1Rx8 registered ECC RDIMM at 1.1 V CL40. It matches the rank, voltage and timing the Supermicro H13SSH memory controller expects so the server recognises the full capacity and runs at the rated speed. The 288-pin registered form factor is the one that board requires.

288-pin registered form factor and population rules

The RDIMM architecture buffers the command and address bus, letting every slot run fully populated at full capacity without overloading the controller. You must follow the motherboard manual for supported capacities, approved DIMM population order and installation steps before fitting the module. No heat spreader is fitted, so airflow in the chassis clears the chips directly.

Registered ECC stability under sustained load

Registered buffering offloads the memory controller during continuous operation while on-die ECC catches and corrects single-bit errors on the fly. This prevents silent data corruption and unplanned reboots from reaching production workloads. The module is backed by lifetime replacement coverage and US-based technical support for the service life of the hardware.

Høydepunkter

  • Exact-match DDR5-4800 16 GB CL40 1Rx8 ECC RDIMM for Supermicro H13SSH
  • 288-pin registered form factor fits the board's required slot type
  • ECC and registered design corrects single-bit errors and stabilises full-population loads
  • 1 V operation matches the platform's native memory voltage spec
  • Lifetime replacement warranty with US-based technical support included

Spesifikasjoner

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR38400-618K1
Capacity16GB
Type288-Pin DDR5 RDIMM
SpeedDDR5 4800 (PC5 38400)
CAS LatencyCL40
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank1Rx8
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content16GB DDR5 4800MHz PC5-38400 1Rx8 1.1V 288-PIN ECC RDIMM KIT

Andre versjoner av denne modellen

5 flere i samme serie

Samme familie, annet minne, annen kjøler eller klokkefrekvens — sammenlign før du bestemmer deg.

Spørsmål om denne varen

Does the DDR5 4800 CL40 timing limit throughput under sustained workloads?

The module runs at its rated DDR5 4800 speed with CL40 latency; registered ECC architecture keeps every slot at full capacity during continuous operation.

How much heat and power does the 1.1V registered DIMM produce when running all day?

At 1.10V the RDIMM draws minimal power and runs without a heat spreader, so thermal output stays low in a populated server chassis.

Must the Supermicro H13SSH motherboard already support DDR5 RDIMM ECC for this upgrade to work?

Yes, the board must accept 288-pin DDR5 registered ECC DIMMs; this kit is spec-matched to the H13SSH memory population rules.

Også i denne avdelingen

Kunder sammenlignet disse

Samme hylle, samme kasse — åtte mynter og 30 minutters kurslås.