Vi tar imot kryptovaluta — slik kan kryptovalutaene du eier, kjøpe ekte maskinvare.Betal med krypto, bruk den på ekte maskinvare. Gratis, forsikret levering verden over for bestillinger over 399 $. Nøytrale kartonger uten merking, sendt fra Tyskland.Gratis, forsikret levering over 399 $. Kursen din er låst i 30 minutter når kassen åpnes.Kurs låst i 30 minutter. Alle varer er forseglet, serienummerkontrollert og dekket av 24 måneders garanti.Forseglet, 24 måneders garanti.

Overvåkingsliste Logg inn

NEMIX RAM

NEMIX RAM 16GB DDR5 5600 CL46 1Rx8 ECC Registered RDIMM Supermicro H14DST-F memory upgrade

SKU CH-DQTH-3PF4R

16 GB DDR5 5600 CL46 registered ECC RDIMM built for Supermicro H14DST-F servers

  • Capacity16GB
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 5600 (PC5 44800)
  • CAS LatencyCL46
  • Voltage1.10V
  • ECCYes
  • Exact-match DDR5-5600 upgrade runs at rated speed
  • Registered ECC design corrects single-bit errors automatically
  • 1Rx8 1.1 V modules fit Supermicro H14DST-F slots
  • 288-pin RDIMM form factor matches board population rules
  • Major OEM DRAM chips deliver enterprise-grade stability

16GB DDR5 ECC RDIMM for Supermicro H14DST-F

This 16GB DDR5-5600 registered ECC module is built to the exact rank, voltage and timing the Supermicro H14DST-F motherboard expects. It installs as a 288-pin RDIMM so the board recognises the full capacity at its rated 5600 MT/s speed without manual configuration.

Thermals noise and power at 1.1V

Operating at 1.10V, the module draws minimal power and generates little heat even when every slot is populated. The registered architecture reduces electrical load on the memory controller, helping the system run cooler and quieter under sustained server workloads.

Build fit population rules and slot freedom

The 1Rx8 organisation lets you fill all supported DIMM slots on the H14DST-F without exceeding the board's rank-per-channel limits. ECC corrects single-bit errors on the fly, protecting data integrity while the registered buffer keeps signal integrity stable across a fully populated configuration.

Høydepunkter

  • Exact-match DDR5-5600 upgrade runs at rated speed
  • Registered ECC design corrects single-bit errors automatically
  • 1Rx8 1.1 V modules fit Supermicro H14DST-F slots
  • 288-pin RDIMM form factor matches board population rules
  • Major OEM DRAM chips deliver enterprise-grade stability

Spesifikasjoner

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR44800-618K1
Capacity16GB
Type288-Pin DDR5 RDIMM
SpeedDDR5 5600 (PC5 44800)
CAS LatencyCL46
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank1Rx8
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content16GB DDR5 5600MHz PC5-44800 1Rx8 1.1V 288-PIN ECC RDIMM KIT

Andre versjoner av denne modellen

5 flere i samme serie

Samme familie, annet minne, annen kjøler eller klokkefrekvens — sammenlign før du bestemmer deg.

Spørsmål om denne varen

How do I install this 288-pin DDR5 RDIMM in the Supermicro H14DST-F, and which step is most often missed?

Power down, open the chassis, and insert the module into the slot specified by the motherboard manual's population order; the step most often missed is verifying the exact DIMM sequence before seating the 1Rx8 registered stick.

What maintenance or replacement will this 16GB ECC registered module need over its service life?

No scheduled maintenance is required; the module carries a lifetime replacement warranty, so it is only swapped if a hardware fault occurs or a capacity upgrade is desired.

What limit appears first when this CL46 1.1V DDR5 RDIMM runs sustained workloads on the H14DST-F?

The registered buffer and ECC logic keep every slot stable at full 5600 speed, so the practical ceiling is the motherboard's maximum supported capacity rather than a thermal or timing bottleneck.

Også i denne avdelingen

Kunder sammenlignet disse

Samme hylle, samme kasse — åtte mynter og 30 minutters kurslås.