Vi tar imot kryptovaluta — slik kan kryptovalutaene du eier, kjøpe ekte maskinvare.Betal med krypto, bruk den på ekte maskinvare. Gratis, forsikret levering verden over for bestillinger over 399 $. Nøytrale kartonger uten merking, sendt fra Tyskland.Gratis, forsikret levering over 399 $. Kursen din er låst i 30 minutter når kassen åpnes.Kurs låst i 30 minutter. Alle varer er forseglet, serienummerkontrollert og dekket av 24 måneders garanti.Forseglet, 24 måneders garanti.

Overvåkingsliste Logg inn
Eight green DDR5 RDIMM modules in a row

NEMIX RAM

NEMIX RAM 768GB (8 x 96GB) DDR5-4800 CL40 2Rx4 ECC RDIMM for Supermicro H14DSG-OD

SKU CH-8DP8-CCMM1

An eight-module kit delivering 768 GB of DDR5-4800 ECC registered memory tuned for the Supermicro H14DSG-OD motherboard

  • Capacity768GB (8 x 96GB)
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 4800 (PC5 38400)
  • CAS LatencyCL40
  • Voltage1.10V
  • ECCYes

Size 768GB 8X96GB

Vis 30 flere konfigurasjoner
  • 768 GB total capacity from eight 96 GB modules for maximum server density
  • DDR5 4800 speed with CL40 latency runs at rated frequency on the Supermicro H14DSG-OD
  • Registered ECC design corrects single-bit errors and offloads the memory controller under full load
  • 2Rx4 organisation and 1.1 V operation match the board's exact electrical requirements
  • 288-pin RDIMM form factor fits the motherboard's DDR5 slots without adapters

Exact-fit 768 GB DDR5-4800 ECC RDIMM kit

This NEMIX RAM kit delivers 768 GB as eight 96 GB DDR5-4800 (PC5-38400) modules. Each 288-pin RDIMM runs at CL40 latency and 1.10 V with 2Rx4 registered ECC architecture. It is built as an exact-match upgrade for the Supermicro H14DSG-OD motherboard so the memory controller recognises full capacity at rated speed.

Suited for fully populated H14DSG-OD servers

The registered design offloads the memory controller, allowing every slot to run fully populated while ECC corrects single-bit errors on the fly. Builders needing unbuffered UDIMMs, SODIMMs, non-ECC modules, or a different DDR generation should look elsewhere because this kit only fits the registered DDR5 RDIMM specification required by the target board.

Check manual for population rules

Server and motherboard memory support varies by model, so consult the Supermicro H14DSG-OD manual for supported capacities, approved DIMM population order, and installation steps before ordering. Verify that your firmware revision accepts the full 768 GB configuration and that the board’s memory controller is rated for eight 2Rx4 modules.

Høydepunkter

  • 768 GB total capacity from eight 96 GB modules for maximum server density
  • DDR5 4800 speed with CL40 latency runs at rated frequency on the Supermicro H14DSG-OD
  • Registered ECC design corrects single-bit errors and offloads the memory controller under full load
  • 2Rx4 organisation and 1.1 V operation match the board's exact electrical requirements
  • 288-pin RDIMM form factor fits the motherboard's DDR5 slots without adapters

Spesifikasjoner

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR38400-9624K8
Capacity768GB (8 x 96GB)
Type288-Pin DDR5 RDIMM
SpeedDDR5 4800 (PC5 38400)
CAS LatencyCL40
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx4
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content768GB 8X96GB DDR5 4800MHz PC5-38400 2Rx4 1.1V 288-PIN ECC RDIMM KIT

Andre versjoner av denne modellen

5 flere i samme serie

Samme familie, annet minne, annen kjøler eller klokkefrekvens — sammenlign før du bestemmer deg.

Spørsmål om denne varen

What motherboard must I already have for this 768GB kit to be recognized at full capacity and rated speed?

The kit is validated for the Supermicro H14DSG-OD motherboard; its memory controller expects the exact 2Rx4 registered ECC timings, 1.1V voltage and CL40 latency this kit provides.

How will these 96GB DDR5-4800 RDIMMs behave if I keep older DDR5 modules in the same server?

Mixing different capacities, ranks or speeds forces the memory controller to run all slots at the lowest common settings, so the 768GB kit would downclock and lose its rated PC5-38400 performance.

How can I confirm the 8 x 96GB modules are running at DDR5-4800 CL40 after installation?

Check the BIOS memory information screen or run a hardware inventory tool; it should report 768GB total, 4800 MT/s data rate, CL40 timings and registered ECC status for every populated slot.

Også i denne avdelingen

Kunder sammenlignet disse

Samme hylle, samme kasse — åtte mynter og 30 minutters kurslås.