Vi tar imot kryptovaluta — slik kan kryptovalutaene du eier, kjøpe ekte maskinvare.Betal med krypto, bruk den på ekte maskinvare. Gratis, forsikret levering verden over for bestillinger over 399 $. Nøytrale kartonger uten merking, sendt fra Tyskland.Gratis, forsikret levering over 399 $. Kursen din er låst i 30 minutter når kassen åpnes.Kurs låst i 30 minutter. Alle varer er forseglet, serienummerkontrollert og dekket av 24 måneders garanti.Forseglet, 24 måneders garanti.

Overvåkingsliste Logg inn
Green rectangular DDR3 memory module with gold edge connector and black chips on both sides

OWC

OWC 8GB DDR3 1600 PC3-12800 CL11 2Rx8 240-pin 1.5V ECC UDIMM for ASUSTOR AS7009RDX AS7012RDX

SKU CH-56GZ-NS7SZ

8 GB DDR3 1600 ECC UDIMM module for ASUSTOR AS7009RDX and AS7012RDX NAS systems

  • Capacity8GB
  • Type240-Pin DDR3 ECC UDIMM
  • SpeedDDR3 1600 (PC3 12800)
  • CAS LatencyCL11
  • Voltage1.5V
  • ECCYes

Capacity 8GB

  • ECC protection guards data integrity in ASUSTOR NAS
  • DDR3 1600 speed matches system bus for stable throughput
  • Single 8 GB module adds capacity without pairing
  • JEDEC-standard 1.5 V unbuffered design ensures warranty-safe upgrade
  • 240-pin UDIMM fits AS7009RDX and AS7012RDX slots directly

OWC 8GB DDR3 ECC UDIMM for ASUSTOR NAS

This OWC module is an 8 GB DDR3 ECC unbuffered UDIMM built to the PC3-12800 1600 MHz CL11 JEDEC standard. It operates at 1.5 V and uses a 240-pin 2Rx8 layout without a heat spreader. The part is validated for ASUSTOR AS7009RDX and AS7012RDX systems as a direct replacement for AS7R-RAM8GEC.

Ideal for owners expanding supported ASUSTOR NAS

Buyers who need to increase memory in an ASUSTOR AS7009RDX or AS7012RDX will find this module matches the required specification. Systems that demand registered DIMMs, a different pin count, non-ECC memory or a voltage other than 1.5 V cannot use this module.

Deciding spec: 240-pin DDR3 ECC unbuffered at 1.5 V

The single detail that determines fit is the 240-pin DDR3 ECC unbuffered design running at 1.5 V with CL11 timing. If the target chassis requires registered memory, a different voltage or another DDR generation this module will not install or function.

Høydepunkter

  • ECC protection guards data integrity in ASUSTOR NAS
  • DDR3 1600 speed matches system bus for stable throughput
  • Single 8 GB module adds capacity without pairing
  • JEDEC-standard 1.5 V unbuffered design ensures warranty-safe upgrade
  • 240-pin UDIMM fits AS7009RDX and AS7012RDX slots directly

Spesifikasjoner

BrandOWC
Part Number1E6D32R808GB
Capacity8GB
Type240-Pin DDR3 ECC UDIMM
SpeedDDR3 1600 (PC3 12800)
CAS LatencyCL11
Voltage1.5V
ECCYes
Buffered/RegisteredUnbuffered
Rank2Rx8
Heat SpreaderNo
Compatible SystemASUSTOR AS7009RDX
ASUSTOR AS7012RDX

Andre versjoner av denne modellen

5 flere i samme serie

Samme familie, annet minne, annen kjøler eller klokkefrekvens — sammenlign før du bestemmer deg.

Spørsmål om denne varen

How do I install the 240-pin DDR3 ECC UDIMM into my ASUSTOR AS7009RDX, and what step is commonly missed?

Power off the NAS, open the chassis, align the notch on the 240-pin module with the slot key, press firmly until both retention clips click, then verify the system recognises the full 8GB at 1600 MHz CL11 on boot.

What maintenance or replacement will the 8GB DDR3 1600 module need over its service life?

The unbuffered ECC UDIMM has no moving parts or heat spreader; it requires no scheduled maintenance and is covered by a limited lifetime warranty, so replacement is only needed if a memory error appears.

What limit appears first when the 1.5V CL11 kit runs sustained workloads on the AS7012RDX?

The module is rated for DDR3 1600 at CL11 1.5V; under continuous load the first ceiling you reach is the JEDEC‑specified speed and latency envelope, not thermal throttling.

Også i denne avdelingen

Kunder sammenlignet disse

Samme hylle, samme kasse — åtte mynter og 30 minutters kurslås.