DELL
DELL 400-ANTU 10TB 3.5" SAS 12Gb/s 7200 RPM internal hard drive
A 10 TB 3.5" SAS 12Gb/s 7200 RPM internal hard drive for desktop storage
- PackagingBare Drive
- InterfaceSAS 12Gb/s
- Capacity10TB
- RPM7200 RPM
- Form Factor3.5"
- 10TB capacity stores large datasets and backups
- SAS 12Gb/s interface delivers fast data transfer rates
- 7200 RPM spindle speed provides responsive performance
- 5 inch form factor fits standard desktop drive bays
- Non hot-swap tray design suits fixed internal installations
Dell 400-ANTU 10TB SAS drive
This is a new Dell 400-ANTU internal hard drive with a 10TB capacity. It uses a 3.5 inch form factor and a SAS 12Gb/s interface spinning at 7200 RPM. The drive is supplied as a bare unit in non hot-swap configuration.
Suitable for SAS storage arrays and servers
The 12Gb/s SAS interface suits storage arrays and servers built for this protocol. It is not for systems that lack a SAS backplane or controller, nor for hot-swap bays that require a drive tray. Builders needing a smaller form factor should look at something else.
SAS 12Gb/s interface decides fit
The single specification that decides fit is the SAS 12Gb/s interface. Your host bus adapter or backplane must support this exact connection. Without a compatible SAS controller the drive will not function.
Öne çıkanlar
- 10TB capacity stores large datasets and backups
- SAS 12Gb/s interface delivers fast data transfer rates
- 7200 RPM spindle speed provides responsive performance
- 5 inch form factor fits standard desktop drive bays
- Non hot-swap tray design suits fixed internal installations
Teknik özellikler
| Brand | Dell |
|---|---|
| Model | 400-ANTU |
| Packaging | Bare Drive |
| Interface | SAS 12Gb/s |
| Capacity | 10TB |
| RPM | 7200 RPM |
| Form Factor | 3.5" |
Bu ürünle ilgili sorular
Will the 3.5" form factor fit a standard desktop drive bay?
Yes, the 3.5" form factor matches standard desktop drive bays and uses the common SAS connector layout.
What is the correct way to install a non hot-swap SAS drive?
Power down the system completely, connect both the SAS data and power cables, then secure the drive with screws before restarting.
How often should I check the 7200 RPM drive for mechanical wear?
Monitor SMART attributes monthly; plan replacement if reallocated sectors or seek errors begin to rise.
Bu reyondan diğerleri
Müşteriler bunları karşılaştırdı
Aynı raf, aynı sipariş tamamlama — sekiz koin ve 30 dakikalık kur kilidi.
