Enfain
Enfain OM3 LC-FC Duplex Multimode Fibre Optic Cable 50m Aqua Blue
A 50-metre OM3 duplex multimode patch cable with LC and FC ceramic ferrules, 3.0 mm PVC jacket, 850 nm wavelength, typical insertion loss of .2 dB and return loss above 38 dB
- Low-loss links with typical insertion loss of .2 dB
- High signal integrity backed by return loss exceeding 38 dB
- 10 Gb/s multimode performance over 50 m at 850 nm
- Durable 3.0 mm PVC jacket rated for 1000 mating cycles
- Reliable operation from -20 °C to 60 °C with 330 mm bend radius
Enfain OM3 Duplex Cable 50m
This 50 metre multimode patch cable connects LC and FC interfaces using an OM3 10-gigabit core. It operates at an 850 nm wavelength and is intended for 1G, 10G and 40G links in switches, data centres and servers. The aqua blue jacket identifies the OM3 rating at a glance.
3.0 mm PVC Jacket and Ceramic Ferrules
A 3.0 mm PVC sheath protects the duplex fibres while ceramic ferrules keep end-face geometry consistent. Typical insertion loss is .2 dB with a maximum of .3 dB, and return loss exceeds 38 dB. The cable withstands 1000 mating cycles and a 330 mm bending radius.
OM3 Core for 10G Multimode Runs
The OM3 core supports 10-gigabit multimode transmission over the full 50 metre length. Buyers needing single-mode reach or longer 40G distances should select a different cable type. Operating temperature ranges from -20 °C to +60 °C.
Öne çıkanlar
- Low-loss links with typical insertion loss of .2 dB
- High signal integrity backed by return loss exceeding 38 dB
- 10 Gb/s multimode performance over 50 m at 850 nm
- Durable 3.0 mm PVC jacket rated for 1000 mating cycles
- Reliable operation from -20 °C to 60 °C with 330 mm bend radius
Teknik özellikler
Bu ürün için henüz yayınlanmış teknik özellik yok.
Bu modelin diğer sürümleri
Aynı seriden 5 tane daha
Aynı aile, farklı bellek, soğutucu veya frekans — karar vermeden önce karşılaştırın.
Bu ürünle ilgili sorular
How many insertion and removal cycles can the LC and FC connectors withstand before replacement?
The connectors are rated for 1000 insertion and removal cycles under normal use.
What is the maximum insertion loss that limits signal reach on this 50 m OM3 link?
Maximum insertion loss is .3 dB per connector at 850 nm, setting the practical loss budget for the link.
How much heat does the cable add when running 10 G traffic continuously in a 60 °C cabinet?
The passive fibre adds no heat; operating temperature range is -20 °C to +60 °C with zero power draw.
Bu reyondan diğerleri
Müşteriler bunları karşılaştırdı
Aynı raf, aynı sipariş tamamlama — sekiz koin ve 30 dakikalık kur kilidi.
Black Box Corporation DisplayPort to DVI Fibre Optic Cable 15 ft 4.5 m 1.35 GB/s
- Consumer Electronics








