Kripto para kabul ediyoruz — böylece elinizdeki koinlerle gerçek donanım alabilirsiniz.Kripto parayla ödeyin, onu gerçek donanıma harcayın. $399 üzeri siparişlerde dünya genelinde sigortalı kargo ücretsizdir. Sade, markasız koliler Almanya’dan gönderilir.$399 üzeri siparişlerde sigortalı kargo ücretsizdir. Ödeme sayfası açıldığında kurunuz 30 dakika kilitli kalır.Kur 30 dakika kilitli. Her ürün mühürlüdür, seri numarası kontrol edilir ve 24 ay garanti kapsamındadır.Mühürlü, 24 ay garantili.

Favori ürünler Giriş yap
Rectangular black ATX power supply unit with label showing 15V 6.7A

KHACHIMO

KHACHIMO RTW15-6R7C 15V 6.7A Power Supply

SKU CH-P0Y3-KVK1J

Delivers 15 volts at 6.7 amps for TDK-Lambda compatible ATX power supply replacement

  • TypeATX
  • Delivers stable 15 V output for TDK-Lambda compatibility
  • Supplies 6.7 A current to meet demanding load requirements
  • ATX form factor fits standard chassis mounting points
  • Tested working and built with good-quality components

15 V 6.7 A ATX power supply

This KHACHIMO RTW15-6R7C unit delivers 15 volts at 6.7 amps in a standard ATX form factor. It is built as a direct-fit replacement for TDK-Lambda power supplies that require the same output specification. The module ships new and has been tested to confirm correct operation.

Replaces failed TDK-Lambda units

Install this supply when the original TDK-Lambda brick has failed or shows unstable voltage under load. The swap is worthwhile when the system chassis and wiring match the ATX layout and the 15 V rail is the only rail the board requires. Builders needing additional rails or different voltages should look elsewhere.

Öne çıkanlar

  • Delivers stable 15 V output for TDK-Lambda compatibility
  • Supplies 6.7 A current to meet demanding load requirements
  • ATX form factor fits standard chassis mounting points
  • Tested working and built with good-quality components

Teknik özellikler

TypeATX

Bu ürünle ilgili sorular

Does the ATX form factor of this 15V 6.7A unit match the mounting holes of my TDK-Lambda chassis?

The supply uses the standard ATX mounting pattern, so it aligns with the four screw holes found on TDK-Lambda cases that accept ATX units.

Which cables must be connected first when installing this 15V 6.7A ATX supply to avoid a no-post condition?

Seat the 24-pin motherboard connector and the 4-pin CPU power plug before switching on the rear rocker; skipping either rail leaves the system dead.

Bu reyondan diğerleri

Müşteriler bunları karşılaştırdı

Aynı raf, aynı sipariş tamamlama — sekiz koin ve 30 dakikalık kur kilidi.