Accettiamo criptovalute — così le crypto che Lei possiede possono comprare hardware reale.Paghi in crypto, la spenda in hardware reale. Spedizione assicurata gratuita in tutto il mondo oltre i 399 $. Cartoni neutri, senza marchio, spediti dalla Germania.Spedizione assicurata gratuita oltre i 399 $. Il Suo tasso resta bloccato per 30 minuti dall’apertura del checkout.Tasso bloccato 30 minuti. Ogni articolo è sigillato, il numero di serie è verificato, ed è coperto da una garanzia di 24 mesi.Sigillato, garantito 24 mesi.

Articoli preferiti Accedi
Rectangular black ATX power supply unit with label showing 15V 6.7A

KHACHIMO

KHACHIMO RTW15-6R7C 15V 6.7A Power Supply

SKU CH-P0Y3-KVK1J

Delivers 15 volts at 6.7 amps for TDK-Lambda compatible ATX power supply replacement

  • TypeATX
  • Delivers stable 15 V output for TDK-Lambda compatibility
  • Supplies 6.7 A current to meet demanding load requirements
  • ATX form factor fits standard chassis mounting points
  • Tested working and built with good-quality components

15 V 6.7 A ATX power supply

This KHACHIMO RTW15-6R7C unit delivers 15 volts at 6.7 amps in a standard ATX form factor. It is built as a direct-fit replacement for TDK-Lambda power supplies that require the same output specification. The module ships new and has been tested to confirm correct operation.

Replaces failed TDK-Lambda units

Install this supply when the original TDK-Lambda brick has failed or shows unstable voltage under load. The swap is worthwhile when the system chassis and wiring match the ATX layout and the 15 V rail is the only rail the board requires. Builders needing additional rails or different voltages should look elsewhere.

Punti di forza

  • Delivers stable 15 V output for TDK-Lambda compatibility
  • Supplies 6.7 A current to meet demanding load requirements
  • ATX form factor fits standard chassis mounting points
  • Tested working and built with good-quality components

Caratteristiche tecniche

TypeATX

Domande su questo articolo

Does the ATX form factor of this 15V 6.7A unit match the mounting holes of my TDK-Lambda chassis?

The supply uses the standard ATX mounting pattern, so it aligns with the four screw holes found on TDK-Lambda cases that accept ATX units.

Which cables must be connected first when installing this 15V 6.7A ATX supply to avoid a no-post condition?

Seat the 24-pin motherboard connector and the 4-pin CPU power plug before switching on the rear rocker; skipping either rail leaves the system dead.

Anche in questo reparto

Anche i clienti hanno confrontato questi

Stesso reparto, stessa cassa — otto monete e un cambio bloccato per 30 minuti.