Aceptamos criptomonedas — así, las criptos que usted tiene pueden comprar hardware real.Pague en cripto y gástela en hardware real. Envío asegurado gratis a nivel mundial a partir de $399. Cajas neutras, sin marca, enviadas desde Alemania.Envío asegurado gratis a partir de $399. Su cotización queda bloqueada 30 minutos en cuanto se abre el pago.Cotización bloqueada 30 minutos. Todos los artículos vienen sellados, con el número de serie verificado y cubiertos por una garantía de 24 meses.Sellado, con 24 meses de garantía.

Artículos guardados Iniciar sesión
Rectangular black ATX power supply unit with label showing 15V 6.7A

KHACHIMO

KHACHIMO RTW15-6R7C 15V 6.7A Power Supply

SKU CH-P0Y3-KVK1J

Delivers 15 volts at 6.7 amps for TDK-Lambda compatible ATX power supply replacement

  • TypeATX
  • Delivers stable 15 V output for TDK-Lambda compatibility
  • Supplies 6.7 A current to meet demanding load requirements
  • ATX form factor fits standard chassis mounting points
  • Tested working and built with good-quality components

15 V 6.7 A ATX power supply

This KHACHIMO RTW15-6R7C unit delivers 15 volts at 6.7 amps in a standard ATX form factor. It is built as a direct-fit replacement for TDK-Lambda power supplies that require the same output specification. The module ships new and has been tested to confirm correct operation.

Replaces failed TDK-Lambda units

Install this supply when the original TDK-Lambda brick has failed or shows unstable voltage under load. The swap is worthwhile when the system chassis and wiring match the ATX layout and the 15 V rail is the only rail the board requires. Builders needing additional rails or different voltages should look elsewhere.

Puntos fuertes

  • Delivers stable 15 V output for TDK-Lambda compatibility
  • Supplies 6.7 A current to meet demanding load requirements
  • ATX form factor fits standard chassis mounting points
  • Tested working and built with good-quality components

Especificaciones

TypeATX

Preguntas sobre este artículo

Does the ATX form factor of this 15V 6.7A unit match the mounting holes of my TDK-Lambda chassis?

The supply uses the standard ATX mounting pattern, so it aligns with the four screw holes found on TDK-Lambda cases that accept ATX units.

Which cables must be connected first when installing this 15V 6.7A ATX supply to avoid a no-post condition?

Seat the 24-pin motherboard connector and the 4-pin CPU power plug before switching on the rear rocker; skipping either rail leaves the system dead.

También en este pasillo

Los clientes también compararon

Mismo estante, mismo pago — ocho criptomonedas y un tipo de cambio bloqueado 30 minutos.