RUCKUS WIRELESS
RUCKUS WIRELESS P01-Q710-US02 2x1000Base-T RJ-45 wireless router
Wireless router with 2x2 MIMO, IPv4 and IPv6 support, four antennas and two 1000Base-T RJ-45 ports
- Dual 1000Base-T RJ-45 ports for wired throughput
- PoE+ support simplifies installation with single-cable power
- 2×2 MIMO technology improves wireless capacity
- Four antennas extend coverage across the space
- 20 W operational draw keeps energy costs low
What this router does and who it fits
The Ruckus P01-Q710-US02 is a wireless router with two 1000Base-T RJ-45 ports and four antennas. It provides a data transfer rate of 200 MBps using 2x2 MIMO technology. The unit supports IPv4, IPv6 and VLAN features for network segmentation. Power Over Ethernet Plus allows the router to be powered through the network cable at 12 V with an operational draw of 20 watts. A mounting bracket is included for installation.
Ideal deployments and mismatched needs
This router suits small offices or branch locations that need a compact, PoE+-powered access point with wired uplinks. It works well where a single Ethernet drop provides both connectivity and power. Buyers who require more than two wired ports or higher throughput than 200 MBps should look at other models. Environments needing outdoor-rated enclosures or advanced mesh protocols will need different hardware.
The spec that decides fit
The two 1000Base-T RJ-45 interfaces define the wired connectivity ceiling; only two Ethernet devices can connect directly. If your deployment needs three or more wired uplinks or downlink ports, this unit cannot meet that requirement without an additional switch.
Öne çıkanlar
- Dual 1000Base-T RJ-45 ports for wired throughput
- PoE+ support simplifies installation with single-cable power
- 2×2 MIMO technology improves wireless capacity
- Four antennas extend coverage across the space
- 20 W operational draw keeps energy costs low
Teknik özellikler
Bu ürün için henüz yayınlanmış teknik özellik yok.
Bu ürünle ilgili sorular
What power source must I already have to run the router?
The router operates on 12 V nominal voltage delivered through a PoE+ connection, so you need a PoE+ injector or switch that can supply at least 20 watts.
Can I connect my existing gigabit wired devices to the two 1000Base-T RJ-45 ports?
Yes, both Ethernet ports support 1000Base-T, allowing your current gigabit devices to link directly at full speed.
How do I verify the router is delivering the rated 200 MBps data transfer rate after setup?
Run a local throughput test between a wired client and a wireless client connected to the 2x2 MIMO radios; sustained results near 200 MBps confirm the link is performing as specified.
Bu reyondan diğerleri
Müşteriler bunları karşılaştırdı
Aynı raf, aynı sipariş tamamlama — sekiz koin ve 30 dakikalık kur kilidi.



