NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Приемаме криптовалута — така монетите, които притежавате, могат да купят истински хардуер.Платете с крипто, похарчете го за истински хардуер. Безплатна застрахована доставка по целия свят над 399 $. Неутрални кашони без марка, изпратени от Германия.Безплатна застрахована доставка над 399 $. Курсът Ви е заключен за 30 минути веднага след отварянето на касата.Курс, заключен за 30 минути. Всеки артикул е запечатан, серийният му номер е проверен, и е покрит с 24-месечна гаранция.Запечатан, 24-месечна гаранция.
Brute Networks
32GB DDR4-2666 ECC registered RDIMM with 2Rx4 organisation, 1.2V operation and 288-pin form factor, validated for HPE 840758-691 compatibility
This Brute Networks module delivers 32GB of DDR4 server memory at 2666 MT/s. It operates at 1.20V with ECC error correction and registered buffering. The 288-pin DIMM uses a 2Rx4 organisation and major-brand chips. It is built as a direct equivalent to HPE part number 840758-691.
This module fits systems that require DDR4-2666 registered ECC memory in a 32GB density. It is not for platforms that accept only unbuffered non-ECC UDIMMs. It is also not for boards limited to lower DDR4 speeds or different pin counts. Buyers needing other capacities or voltages should choose a different part.
The single specification that decides fit is the DDR4-2666 (PC4-21300) speed grade. The memory controller must support this exact data rate for the module to run at its rated frequency. If the platform only qualifies slower or faster DDR4 grades, this DIMM will not operate as specified.
| Brand | HPE |
|---|---|
| Capacity | 32GB |
| Type | 288-Pin DDR4 SDRAM |
| Speed | DDR4 2666 (PC4 21300) |
| Voltage | 1.20V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 2Rx4 |
| Chipset | Major Brand Chipset |
The module operates at 2666 MT/s, delivering the full PC4-21300 bandwidth when the platform supports that data rate.
Yes, the 288-pin RDIMM form factor matches standard DDR4 server slots used in HPE systems that accept registered memory.
Power down the server, open the chassis, align the notch on the 288-pin edge connector with the slot key, press firmly until both retention clips click, then verify the configuration in BIOS.
Още от този рафт
Същият рафт, същата каса — осем монети и заключване на курса за 30 минути.
Това, което изпращате, и това, в което четете цените.
Изпратено от Вашия портфейл при поръчката
Само за визуализация — каталогът е в долари
Никоя валута не съответства.
Изберете езика, на който сайтът да Ви говори.
Нови сте тук?
Вече имате профил?
Няма автоматично нулиране: този магазин не изпраща имейли, така че няма еднократна връзка, която да поискате. Оставете адреса в профила си и той ще бъде обработен ръчно.
Заявката е приета
Нищо няма да пристигне във Вашата пощенска кутия — този магазин изобщо не изпраща имейли. Заявките се обработват ръчно.
Спомнихте си я?