NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.
Brute Networks
32GB DDR4-2666 ECC registered RDIMM with 2Rx4 organisation, 1.2V operation and 288-pin form factor, validated for HPE 840758-691 compatibility
This Brute Networks module delivers 32GB of DDR4 server memory at 2666 MT/s. It operates at 1.20V with ECC error correction and registered buffering. The 288-pin DIMM uses a 2Rx4 organisation and major-brand chips. It is built as a direct equivalent to HPE part number 840758-691.
This module fits systems that require DDR4-2666 registered ECC memory in a 32GB density. It is not for platforms that accept only unbuffered non-ECC UDIMMs. It is also not for boards limited to lower DDR4 speeds or different pin counts. Buyers needing other capacities or voltages should choose a different part.
The single specification that decides fit is the DDR4-2666 (PC4-21300) speed grade. The memory controller must support this exact data rate for the module to run at its rated frequency. If the platform only qualifies slower or faster DDR4 grades, this DIMM will not operate as specified.
| Brand | HPE |
|---|---|
| Capacity | 32GB |
| Type | 288-Pin DDR4 SDRAM |
| Speed | DDR4 2666 (PC4 21300) |
| Voltage | 1.20V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 2Rx4 |
| Chipset | Major Brand Chipset |
The module operates at 2666 MT/s, delivering the full PC4-21300 bandwidth when the platform supports that data rate.
Yes, the 288-pin RDIMM form factor matches standard DDR4 server slots used in HPE systems that accept registered memory.
Power down the server, open the chassis, align the notch on the 288-pin edge connector with the slot key, press firmly until both retention clips click, then verify the configuration in BIOS.
Myös tällä osastolla
Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.
Valuutta, jolla maksetaan, sekä valuutta, jossa hinnat näytetään.
Lähetetään lompakostasi kassalla
Vain näyttöä varten — hinnat ovat Yhdysvaltain dollareissa
Valuuttaa ei löytynyt.
Valitse kieli, jolla sivusto puhuu sinulle.
Uusi täällä?
Onko sinulla jo tili?
Automaattista palautusta ei ole: kauppa ei lähetä sähköpostia lainkaan, joten kertakäyttöistä linkkiä ei ole mistä pyytää. Jätä osoite tilille, niin se käsitellään käsin.
Pyyntö kirjattu
Mikään ei ole tulossa sähköpostiisi — tämä kauppa ei lähetä sähköpostia lainkaan. Joku käsittelee nämä pyynnöt käsin.
Muistitko sen?