NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Приемаме криптовалута — така монетите, които притежавате, могат да купят истински хардуер.Платете с крипто, похарчете го за истински хардуер. Безплатна застрахована доставка по целия свят над 399 $. Неутрални кашони без марка, изпратени от Германия.Безплатна застрахована доставка над 399 $. Курсът Ви е заключен за 30 минути веднага след отварянето на касата.Курс, заключен за 30 минути. Всеки артикул е запечатан, серийният му номер е проверен, и е покрит с 24-месечна гаранция.Запечатан, 24-месечна гаранция.
KHACHIMO
ATX power supply delivering 48 volts at 30 amps for 1600 watts of output
The KHACHIMO R4830N2 is a 48V 30A unit rated at 1600W built to the ATX form factor. It targets system integrators and enthusiasts assembling high-current workstations or server-grade platforms that demand sustained 48-volt delivery. Buyers needing standard 12V-only ATX power or lower-wattage units for typical desktop builds should look elsewhere.
The defining specification is the 48-volt rail capable of 30 amps continuous output, yielding the 1600W total capacity. This single rail design dictates compatibility; the power supply only suits hardware engineered for 48V input such as certain GPU compute trays, telecom chassis or specialised industrial boards. Systems expecting conventional 12V ATX distribution cannot use this unit.
Mechanical installation follows standard ATX mounting hole spacing so it fits regular chassis bays without adapters. The primary risk is wiring the 48V output to equipment rated for 12V, which causes immediate damage. Verify every load device accepts 48V before connecting and confirm the mainboard or backplane pin-out matches the supply’s connector layout. No software configuration is required.
| Type | ATX |
|---|
The unit can deliver up to 1600 watts from its 48 volt rail at 30 amps, so a system drawing that power on the 48 volt line will run within its rated capacity.
As an ATX supply it fits standard ATX mounting holes and provides the usual motherboard and peripheral connectors, but it only offers a single 48 volt output rather than multiple rails.
It uses the standard ATX footprint, so it will mount in any case with an ATX power-supply bay and the usual four screw holes.
Още от този рафт
Същият рафт, същата каса — осем монети и заключване на курса за 30 минути.
Това, което изпращате, и това, в което четете цените.
Изпратено от Вашия портфейл при поръчката
Само за визуализация — каталогът е в долари
Никоя валута не съответства.
Изберете езика, на който сайтът да Ви говори.
Нови сте тук?
Вече имате профил?
Няма автоматично нулиране: този магазин не изпраща имейли, така че няма еднократна връзка, която да поискате. Оставете адреса в профила си и той ще бъде обработен ръчно.
Заявката е приета
Нищо няма да пристигне във Вашата пощенска кутия — този магазин изобщо не изпраща имейли. Заявките се обработват ръчно.
Спомнихте си я?