Приемаме криптовалута — така монетите, които притежавате, могат да купят истински хардуер.Платете с крипто, похарчете го за истински хардуер. Безплатна застрахована доставка по целия свят над 399 $. Неутрални кашони без марка, изпратени от Германия.Безплатна застрахована доставка над 399 $. Курсът Ви е заключен за 30 минути веднага след отварянето на касата.Курс, заключен за 30 минути. Всеки артикул е запечатан, серийният му номер е проверен, и е покрит с 24-месечна гаранция.Запечатан, 24-месечна гаранция.

Проследени артикули Вход

NEMIX RAM

NEMIX RAM DDR5 4800 ECC UDIMM 16GB CL40 1.1V 1Rx8 Supermicro X14SAE memory upgrade

SKU CH-W77M-T34S5

16 GB DDR5-4800 ECC UDIMM with CL40 timing and 1.1 V operation, verified for Supermicro X14SAE motherboards

  • Capacity16GB
  • Type288-Pin DDR5 ECC UDIMM
  • SpeedDDR5 4800 (PC5 38400)
  • CAS LatencyCL40
  • Voltage1.10V
  • ECCYes
  • ECC detects and corrects single-bit errors preventing data corruption
  • Exact-match DDR5-4800 PC5-38400 CL40 1.10V 1Rx8 runs at rated speed
  • Verified fit for Supermicro X14SAE motherboard 288-pin UDIMM slot
  • Unbuffered ECC module uses major OEM Samsung Micron Hynix chips
  • Lifetime replacement warranty with free US-based technical support

Exact DDR5-4800 ECC UDIMM for Supermicro X14SAE

This 16 GB DDR5 4800 module is built to the precise rank, voltage and timing the Supermicro X14SAE memory controller expects. It installs as a 288-pin unbuffered ECC UDIMM and runs at the board's rated speed without manual tuning.

Who this suits and who should look elsewhere

It suits administrators upgrading a Supermicro X14SAE platform that requires DDR5-4800 ECC unbuffered memory in a 1Rx8 configuration. Builders needing RDIMM, SODIMM, non-ECC, higher capacities or different speeds should look elsewhere.

The specification that decides fit

The module is a 288-pin DDR5-4800 ECC unbuffered UDIMM with CL40 latency, 1.1 V operation and 1Rx8 organisation; only systems that explicitly support this exact combination will recognise the full 16 GB at rated speed.

Акценти

  • ECC detects and corrects single-bit errors preventing data corruption
  • Exact-match DDR5-4800 PC5-38400 CL40 1.10V 1Rx8 runs at rated speed
  • Verified fit for Supermicro X14SAE motherboard 288-pin UDIMM slot
  • Unbuffered ECC module uses major OEM Samsung Micron Hynix chips
  • Lifetime replacement warranty with free US-based technical support

Спецификации

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Memory
ModelDDR5 ECC Unbuffered UDIMM Memory
Part NumberME38400-618K1
Capacity16GB
Type288-Pin DDR5 ECC UDIMM
SpeedDDR5 4800 (PC5 38400)
CAS LatencyCL40
Voltage1.10V
ECCYes
Buffered/RegisteredUnbuffered
Rank1Rx8
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 ECC Unbuffered UDIMM Motherboard Compatible
Package Content16GB DDR5 4800MHz PC5-38400 1Rx8 1.1V 288-PIN ECC UDIMM KIT

Други версии на този модел

5 още от същата серия

Същото семейство, различна памет, охладител или честота — сравнете, преди да решите.

Въпроси за този артикул

My Supermicro X14SAE board requires DDR5 4800 ECC UDIMM modules — does this 16 GB stick match that exact spec?

Yes, it is a 288-pin DDR5 4800 (PC5-38400) 1Rx8 ECC unbuffered UDIMM at 1.10 V CL40 built to the board's required rank, voltage and timing.

I plan to keep my existing DDR5 4800 ECC UDIMM modules — will this 1Rx8 16 GB kit work alongside them?

It shares the same DDR5 4800 speed, 1.10 V voltage and ECC unbuffered design, so it can run with identical modules when installed in the order the motherboard manual specifies.

After installation, how can I confirm the module is running at DDR5 4800 with ECC active?

Open the BIOS memory summary and verify the installed capacity shows 16 GB at 4800 MT/s with ECC reported as enabled.

Още от този рафт

Често сравнявани заедно

Същият рафт, същата каса — осем монети и заключване на курса за 30 минути.