Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään

NEMIX RAM

NEMIX RAM DDR5 4800 ECC UDIMM 16GB CL40 1.1V 1Rx8 Supermicro X14SAE memory upgrade

SKU CH-W77M-T34S5

16 GB DDR5-4800 ECC UDIMM with CL40 timing and 1.1 V operation, verified for Supermicro X14SAE motherboards

  • Capacity16GB
  • Type288-Pin DDR5 ECC UDIMM
  • SpeedDDR5 4800 (PC5 38400)
  • CAS LatencyCL40
  • Voltage1.10V
  • ECCYes
  • ECC detects and corrects single-bit errors preventing data corruption
  • Exact-match DDR5-4800 PC5-38400 CL40 1.10V 1Rx8 runs at rated speed
  • Verified fit for Supermicro X14SAE motherboard 288-pin UDIMM slot
  • Unbuffered ECC module uses major OEM Samsung Micron Hynix chips
  • Lifetime replacement warranty with free US-based technical support

Exact DDR5-4800 ECC UDIMM for Supermicro X14SAE

This 16 GB DDR5 4800 module is built to the precise rank, voltage and timing the Supermicro X14SAE memory controller expects. It installs as a 288-pin unbuffered ECC UDIMM and runs at the board's rated speed without manual tuning.

Who this suits and who should look elsewhere

It suits administrators upgrading a Supermicro X14SAE platform that requires DDR5-4800 ECC unbuffered memory in a 1Rx8 configuration. Builders needing RDIMM, SODIMM, non-ECC, higher capacities or different speeds should look elsewhere.

The specification that decides fit

The module is a 288-pin DDR5-4800 ECC unbuffered UDIMM with CL40 latency, 1.1 V operation and 1Rx8 organisation; only systems that explicitly support this exact combination will recognise the full 16 GB at rated speed.

Kohokohdat

  • ECC detects and corrects single-bit errors preventing data corruption
  • Exact-match DDR5-4800 PC5-38400 CL40 1.10V 1Rx8 runs at rated speed
  • Verified fit for Supermicro X14SAE motherboard 288-pin UDIMM slot
  • Unbuffered ECC module uses major OEM Samsung Micron Hynix chips
  • Lifetime replacement warranty with free US-based technical support

Tekniset tiedot

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Memory
ModelDDR5 ECC Unbuffered UDIMM Memory
Part NumberME38400-618K1
Capacity16GB
Type288-Pin DDR5 ECC UDIMM
SpeedDDR5 4800 (PC5 38400)
CAS LatencyCL40
Voltage1.10V
ECCYes
Buffered/RegisteredUnbuffered
Rank1Rx8
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 ECC Unbuffered UDIMM Motherboard Compatible
Package Content16GB DDR5 4800MHz PC5-38400 1Rx8 1.1V 288-PIN ECC UDIMM KIT

Tämän mallin muut versiot

5 lisää samasta mallistosta

Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.

Kysymyksiä tästä tuotteesta

My Supermicro X14SAE board requires DDR5 4800 ECC UDIMM modules — does this 16 GB stick match that exact spec?

Yes, it is a 288-pin DDR5 4800 (PC5-38400) 1Rx8 ECC unbuffered UDIMM at 1.10 V CL40 built to the board's required rank, voltage and timing.

I plan to keep my existing DDR5 4800 ECC UDIMM modules — will this 1Rx8 16 GB kit work alongside them?

It shares the same DDR5 4800 speed, 1.10 V voltage and ECC unbuffered design, so it can run with identical modules when installed in the order the motherboard manual specifies.

After installation, how can I confirm the module is running at DDR5 4800 with ECC active?

Open the BIOS memory summary and verify the installed capacity shows 16 GB at 4800 MT/s with ECC reported as enabled.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.