NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Приемаме криптовалута — така монетите, които притежавате, могат да купят истински хардуер.Платете с крипто, похарчете го за истински хардуер. Безплатна застрахована доставка по целия свят над 399 $. Неутрални кашони без марка, изпратени от Германия.Безплатна застрахована доставка над 399 $. Курсът Ви е заключен за 30 минути веднага след отварянето на касата.Курс, заключен за 30 минути. Всеки артикул е запечатан, серийният му номер е проверен, и е покрит с 24-месечна гаранция.Запечатан, 24-месечна гаранция.
RIMLANCE
16 GB DDR4 2133 ECC registered RDIMM with CL15 latency and 2Rx4 organisation
This RIMLANCE module is a 16GB DDR4 2133MHz PC4-17000 ECC Registered DIMM built for servers and workstations. It uses a 2Rx4 organisation and operates at 1.2V across 288 pins. The CL15 timing supports stable data handling in multi-socket platforms that require registered memory with error correction.
The jump is worthwhile when your platform mandates registered ECC memory for data integrity and signal integrity across full memory channels. Systems designed for unbuffered or non-ECC modules cannot use this RDIMM, and mixing registered with unbuffered DIMMs will prevent boot. Verify your motherboard or server manual specifies RDIMM support before purchasing.
The DDR4 2133 standard caps transfer rates at 2133 MT/s, and the registered buffer adds one clock cycle of latency versus unbuffered equivalents. Maximum capacity per channel depends on the memory controller and BIOS, not on this module alone. Populations beyond the vendor-qualified DIMM-per-channel count may force lower speeds or fail to initialise.
| Brand | RIMLANCE |
|---|---|
| Model | RRD17000D4C16 |
| Capacity | 16GB |
| Type | 288-Pin DDR4 SDRAM |
| Speed | DDR4 2133 (PC4 17000) |
| CAS Latency | CL15 |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 2Rx4 |
| Chipset | Major Brand Chipset |
This module uses the standard 288-pin DDR4 RDIMM form factor and operates at 1.2 V. It fits server and workstation boards that support registered ECC DDR4 memory.
Power down the system, open the chassis, align the notch on the 288-pin edge connector with the slot key, press firmly until the retention clips click. The step often missed is confirming the BIOS recognises the full 16 GB capacity and the CL15 timing at 2133 MT/s.
No scheduled maintenance is required for the DRAM chips or the registered buffer. The module is validated with major-brand chipsets and covered by a lifetime replacement warranty; replace only if a memory diagnostic reports uncorrectable errors.
Още от този рафт
Същият рафт, същата каса — осем монети и заключване на курса за 30 минути.
Това, което изпращате, и това, в което четете цените.
Изпратено от Вашия портфейл при поръчката
Само за визуализация — каталогът е в долари
Никоя валута не съответства.
Изберете езика, на който сайтът да Ви говори.
Нови сте тук?
Вече имате профил?
Няма автоматично нулиране: този магазин не изпраща имейли, така че няма еднократна връзка, която да поискате. Оставете адреса в профила си и той ще бъде обработен ръчно.
Заявката е приета
Нищо няма да пристигне във Вашата пощенска кутия — този магазин изобщо не изпраща имейли. Заявките се обработват ръчно.
Спомнихте си я?