NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Vi tar imot kryptovaluta — slik kan kryptovalutaene du eier, kjøpe ekte maskinvare.Betal med krypto, bruk den på ekte maskinvare. Gratis, forsikret levering verden over for bestillinger over 399 $. Nøytrale kartonger uten merking, sendt fra Tyskland.Gratis, forsikret levering over 399 $. Kursen din er låst i 30 minutter når kassen åpnes.Kurs låst i 30 minutter. Alle varer er forseglet, serienummerkontrollert og dekket av 24 måneders garanti.Forseglet, 24 måneders garanti.
RIMLANCE
16 GB DDR4 2133 ECC registered RDIMM with CL15 latency and 2Rx4 organisation
This RIMLANCE module is a 16GB DDR4 2133MHz PC4-17000 ECC Registered DIMM built for servers and workstations. It uses a 2Rx4 organisation and operates at 1.2V across 288 pins. The CL15 timing supports stable data handling in multi-socket platforms that require registered memory with error correction.
The jump is worthwhile when your platform mandates registered ECC memory for data integrity and signal integrity across full memory channels. Systems designed for unbuffered or non-ECC modules cannot use this RDIMM, and mixing registered with unbuffered DIMMs will prevent boot. Verify your motherboard or server manual specifies RDIMM support before purchasing.
The DDR4 2133 standard caps transfer rates at 2133 MT/s, and the registered buffer adds one clock cycle of latency versus unbuffered equivalents. Maximum capacity per channel depends on the memory controller and BIOS, not on this module alone. Populations beyond the vendor-qualified DIMM-per-channel count may force lower speeds or fail to initialise.
| Brand | RIMLANCE |
|---|---|
| Model | RRD17000D4C16 |
| Capacity | 16GB |
| Type | 288-Pin DDR4 SDRAM |
| Speed | DDR4 2133 (PC4 17000) |
| CAS Latency | CL15 |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 2Rx4 |
| Chipset | Major Brand Chipset |
This module uses the standard 288-pin DDR4 RDIMM form factor and operates at 1.2 V. It fits server and workstation boards that support registered ECC DDR4 memory.
Power down the system, open the chassis, align the notch on the 288-pin edge connector with the slot key, press firmly until the retention clips click. The step often missed is confirming the BIOS recognises the full 16 GB capacity and the CL15 timing at 2133 MT/s.
No scheduled maintenance is required for the DRAM chips or the registered buffer. The module is validated with major-brand chipsets and covered by a lifetime replacement warranty; replace only if a memory diagnostic reports uncorrectable errors.
Også i denne avdelingen
Samme hylle, samme kasse — åtte mynter og 30 minutters kurslås.
Det du betaler med, og det du ser prisene i.
Sendes fra lommeboken din i kassen
Kun visning — katalogen er prissatt i USD
Fant ingen valuta.
Velg språket nettstedet snakker til deg på.
Ny her?
Har du allerede en konto?
Det finnes ingen automatisk tilbakestilling: butikken sender ikke e-post, så det finnes ingen engangslenke å be om. La adressen stå på kontoen, så blir den behandlet manuelt.
Forespørsel registrert
Ingenting er på vei til innboksen din — butikken sender ingen e-post i det hele tatt. Noen behandler dette manuelt.
Husket du det likevel?