Vszerda
Vszerda 2-Pack 90° USB 3.0 19/20Pin Motherboard Adapter
Two right-angle 19/20-pin adapters route internal USB 3.0 cables up or down at 90 degrees for 5 Gbps transfer while reducing strain and clutter
- Right-angle design reduces cable strain on motherboard headers
- Two adapters included: one up-angle and one down-angle for flexible routing
- USB 3.0 interface delivers up to 5 Gbps transfer speed
- ABS construction resists dust and adds durability
- Male-to-female 19/20-pin connector fits internal front-panel USB headers
90° 19/20-pin USB 3.0 adapter kit
The Vszerda two-pack supplies one upward-angled and one downward-angled 19/20-pin adapter that plugs between a motherboard header and a front-panel USB 3.0 cable. Each L-shaped connector removes the need to bend thick internal cables, reducing strain on the header and tidying cable routing behind the motherboard tray. The ABS housing is lightweight and dust-resistant. Builders working in tight chassis or around bulky fan shrouds gain a cleaner internal layout.
Replaces a straight 19/20-pin header connection
A standard straight plug forces the USB 3.0 cable into a sharp bend that can stress the motherboard pins and block airflow. The angled adapters reroute the cable parallel to the board, so the upgrade is worthwhile whenever the header sits close to a graphics card, power connector or case wall. If the current cable already reaches without tension or the header is fully exposed, the adapter adds no benefit. The two orientations cover most header rotations found on modern desktop boards.
Carries USB 3.0 traffic at 5 Gbps
The adapter passes the full USB 3.0 signalling rate of 5 Gbps, ten times the 2.0 ceiling, and supports simultaneous bi-directional transfer. Headroom is sufficient for any front-panel USB 3.0 port, including high-speed flash drives and external SSDs. It does not add bandwidth beyond the header specification, so devices that require USB 3.1 or 3.2 speeds will operate at the 3.0 limit. The solid ABS body resists deformation, but the maker warns against pulling the adapter straight out after installation to avoid pin damage.
Акценти
- Right-angle design reduces cable strain on motherboard headers
- Two adapters included: one up-angle and one down-angle for flexible routing
- USB 3.0 interface delivers up to 5 Gbps transfer speed
- ABS construction resists dust and adds durability
- Male-to-female 19/20-pin connector fits internal front-panel USB headers
Спецификации
Все още няма публикувани спецификации за този артикул.
Въпроси за този артикул
Does the 19/20-pin male connector fit directly onto the motherboard header?
Yes, the male end plugs straight into the board's 19/20-pin USB 3.0 header; the 90-degree bend lets the cable run parallel to the board instead of sticking out.
Which way should I orient the up-angle versus the down-angle adapter during installation?
Check the header's position relative to nearby components — use the up-angle if the cable must route upward, the down-angle if it must route downward — and insert the adapter gently without forcing the pins.
Will the ABS housing degrade or need replacement after repeated case openings?
The ABS shell is dust-resistant and rated for long-term use; it does not require scheduled replacement unless physical damage occurs during removal.
Още от този рафт
Често сравнявани заедно
Същият рафт, същата каса — осем монети и заключване на курса за 30 минути.
Black Box Corporation
Black Box Corporation DisplayPort to DVI Fibre Optic Cable 15 ft 4.5 m 1.35 GB/s
- Consumer Electronics
39,99 щ.д.
0.00051774BTC
В наличност