نقبل الدفع بالعملة المشفرة — لذلك يمكن للعملات الرقمية التي تملكها أن تشتري أجهزة حقيقية.ادفع بالعملة المشفرة، وأنفقها على أجهزة حقيقية. شحن مؤمن مجانا إلى كل أنحاء العالم لما يتجاوز 399 US$. صناديق شحن بسيطة بلا علامة تجارية، ترسل من ألمانيا.شحن مؤمن مجانا لما يتجاوز 399 US$. يُقفل سعرك لمدة 30 دقيقة بمجرد فتح صفحة الدفع.السعر مقفل لمدة 30 دقيقة. كل قطعة مختومة، ورقمها التسلسلي متحقق منه، ومشمولة بضمان 24 شهرا.مختوم، وبضمان 24 شهرا.

قائمة الرصد تسجيل الدخول

Vszerda

Vszerda 2-Pack 90° USB 3.0 19/20Pin Motherboard Adapter

SKU CH-YH9T-JXBKJ

Two right-angle 19/20-pin adapters route internal USB 3.0 cables up or down at 90 degrees for 5 Gbps transfer while reducing strain and clutter

  • Right-angle design reduces cable strain on motherboard headers
  • Two adapters included: one up-angle and one down-angle for flexible routing
  • USB 3.0 interface delivers up to 5 Gbps transfer speed
  • ABS construction resists dust and adds durability
  • Male-to-female 19/20-pin connector fits internal front-panel USB headers

90° 19/20-pin USB 3.0 adapter kit

The Vszerda two-pack supplies one upward-angled and one downward-angled 19/20-pin adapter that plugs between a motherboard header and a front-panel USB 3.0 cable. Each L-shaped connector removes the need to bend thick internal cables, reducing strain on the header and tidying cable routing behind the motherboard tray. The ABS housing is lightweight and dust-resistant. Builders working in tight chassis or around bulky fan shrouds gain a cleaner internal layout.

Replaces a straight 19/20-pin header connection

A standard straight plug forces the USB 3.0 cable into a sharp bend that can stress the motherboard pins and block airflow. The angled adapters reroute the cable parallel to the board, so the upgrade is worthwhile whenever the header sits close to a graphics card, power connector or case wall. If the current cable already reaches without tension or the header is fully exposed, the adapter adds no benefit. The two orientations cover most header rotations found on modern desktop boards.

Carries USB 3.0 traffic at 5 Gbps

The adapter passes the full USB 3.0 signalling rate of 5 Gbps, ten times the 2.0 ceiling, and supports simultaneous bi-directional transfer. Headroom is sufficient for any front-panel USB 3.0 port, including high-speed flash drives and external SSDs. It does not add bandwidth beyond the header specification, so devices that require USB 3.1 or 3.2 speeds will operate at the 3.0 limit. The solid ABS body resists deformation, but the maker warns against pulling the adapter straight out after installation to avoid pin damage.

أبرز المميزات

  • Right-angle design reduces cable strain on motherboard headers
  • Two adapters included: one up-angle and one down-angle for flexible routing
  • USB 3.0 interface delivers up to 5 Gbps transfer speed
  • ABS construction resists dust and adds durability
  • Male-to-female 19/20-pin connector fits internal front-panel USB headers

المواصفات

لا توجد مواصفات منشورة لهذا المنتج بعد.

أسئلة حول هذا المنتج

Does the 19/20-pin male connector fit directly onto the motherboard header?

Yes, the male end plugs straight into the board's 19/20-pin USB 3.0 header; the 90-degree bend lets the cable run parallel to the board instead of sticking out.

Which way should I orient the up-angle versus the down-angle adapter during installation?

Check the header's position relative to nearby components — use the up-angle if the cable must route upward, the down-angle if it must route downward — and insert the adapter gently without forcing the pins.

Will the ABS housing degrade or need replacement after repeated case openings?

The ABS shell is dust-resistant and rated for long-term use; it does not require scheduled replacement unless physical damage occurs during removal.

أيضًا في هذا القسم

عملاء قارنوا هذه المنتجات

نفس القسم، ونفس صفحة الدفع — ثماني عملات رقمية وقفل سعر لمدة 30 دقيقة.