DELL
DELL P2DKC 8TB 3.5" SAS 12Gb/s 7200 RPM
An 8 TB desktop hard drive with a 12 Gb/s SAS interface, 7200 RPM speed and hot-swap 3.5" form factor
- PackagingBare Drive
- InterfaceSAS 12Gb/s
- Capacity8TB
- RPM7200 RPM
- Form Factor3.5"
- 8 TB capacity stores large data sets
- SAS 12 Gb/s interface enables fast transfers
- 7200 RPM spindle speed supports steady throughput
- 5 inch form factor fits standard bays
- Hot-swap tray allows drive changes without power-down
Dell 8TB Nearline SAS 12Gb/s Drive
This Dell P2DKC is a 3.5-inch 8TB nearline SAS hard drive spinning at 7200 RPM with a 12Gb/s interface. It is built for bulk storage in servers or workstations that accept hot-swap SAS drives. The bare-drive packaging suits integrators and IT teams refreshing Dell arrays.
Who this suits and who should look elsewhere
It suits administrators expanding nearline capacity in compatible Dell PowerEdge or Precision systems with SAS backplanes and hot-swap bays. Buyers whose chassis or controller only support slower SAS speeds, smaller form factors, or non-hot-swap caddies should look elsewhere.
The deciding specification
The 12Gb/s SAS interface is the single specification that decides fitment; the drive will only operate at full speed when connected to a 12Gb/s SAS controller and backplane.
Fordele
- 8 TB capacity stores large data sets
- SAS 12 Gb/s interface enables fast transfers
- 7200 RPM spindle speed supports steady throughput
- 5 inch form factor fits standard bays
- Hot-swap tray allows drive changes without power-down
Specifikationer
| Brand | Dell |
|---|---|
| Model | P2DKC |
| Packaging | Bare Drive |
| Interface | SAS 12Gb/s |
| Capacity | 8TB |
| RPM | 7200 RPM |
| Form Factor | 3.5" |
Spørgsmål om denne vare
Does the 3.5" SAS drive fit a standard hot-swap tray?
Yes, the 3.5" form factor matches standard SAS hot-swap bays and the drive is built for hot-swap use.
What is the correct way to install the drive in a hot-swap bay?
Insert the drive firmly until the SAS connector seats fully; the common error is stopping before the latch clicks.
How often should the 7200 RPM drive be replaced in a nearline workload?
Plan replacement around the manufacturer's rated annualised failure rate for 7.2K nearline drives, typically after three to five years of continuous operation.
Også på denne hylde
Kunderne har også sammenlignet disse
Samme hylde, samme kasse — otte mønter og 30 minutters kurslås.
