HP
HP DPS-460FB 460W server power supply
460-watt server power supply compatible with HP DL380 G6 and G7 systems
- 460 watt output powers demanding server workloads
- Compatible with DL380 G6 and G7 platforms
- Switching design delivers efficient 12 volt power
- Lightweight 2.0 pound unit eases installation
- Multiple part numbers simplify ordering and replacement
HP DPS-460FB 460W Server PSU
The HP DPS-460FB is a 460W 12V switching power supply built for HP DL380 G6 and G7 rack servers. It fits the common slot form factor used across these platforms and carries part numbers 599381-001, 591553-001 and 593188-B21. Administrators maintaining existing G6 or G7 infrastructure will find it a direct replacement for failed or ageing units.
Replaces G6/G7 units
This supply replaces the original 460W module shipped with DL380 G6 and G7 servers. The jump is worth it when an existing unit shows fan noise, voltage drift or complete failure, or when a spare is needed for cold-standby redundancy. It is not for builders needing higher wattage, different form factors or support for newer server generations.
460W headroom
At 460W the unit comfortably handles typical dual-socket configurations with standard memory and storage complements in G6 and G7 chassis. Headroom narrows with high-TDP processors, large drive counts or multiple GPU accelerators. It is not for deployments that exceed the 460W rating or require redundant hot-swap frames beyond the native server design.
Fordele
- 460 watt output powers demanding server workloads
- Compatible with DL380 G6 and G7 platforms
- Switching design delivers efficient 12 volt power
- Lightweight 2.0 pound unit eases installation
- Multiple part numbers simplify ordering and replacement
Specifikationer
Der er endnu ikke offentliggjort specifikationer for denne vare.
Spørgsmål om denne vare
Which HP ProLiant DL380 servers accept the DPS-460FB 460W supply?
The unit is listed for HP ProLiant DL380 G6 and G7 servers and matches part numbers 599381-001, 591553-001 and 593188-B21.
How do I install the power supply in the chassis?
Slide the unit into the hot-plug bay until the latch clicks, then secure the retention lever; the common error is leaving the lever unlatched.
When should the internal fan be cleaned or the unit replaced?
Clean the fan intake when dust builds up, typically every 12 months; replace the supply if it fails to power on or shows output errors.
Også på denne hylde
Kunderne har også sammenlignet disse
Samme hylde, samme kasse — otte mønter og 30 minutters kurslås.
Mushkin Enhanced 4GB DDR2-800 CL6 SoDIMM Apple 971741A memory upgrade
SK hynix HYMD232M646C6-J 256MB DDR 333MHz PC2700 CL2.5 SODIMM laptop RAM
- 4GB (2 x 2GB)



