Kingston Technology Corp.
Kingston Technology Corp. 32GB DDR5-5600 CL46 UDIMM 2Rx8 1.1V 288-Pin Samsung Desktop Memory M323R4GA3DB0-CWM
A single 32 GB DDR5 module running at 5600 MHz with CL46 latency, 1.1 V operation and dual-rank 2Rx8 organisation on a 288-pin UDIMM
- 32 GB capacity for demanding desktop workloads
- DDR5 5600 MHz speed for high bandwidth
- CL46 latency tuned for JEDEC standard operation
- 1 V voltage reduces power draw
- 288-pin UDIMM fits standard desktop slots
32 GB DDR5-5600 UDIMM module
This single 32 GB DDR5 module runs at 5600 MHz with CL46 timings at the standard 1.1 V JEDEC voltage. It uses a 288-pin UDIMM form factor and dual-rank 2Rx8 organisation built on Samsung components. The non-ECC unbuffered design targets mainstream desktop platforms that support DDR5 memory.
Suitable for DDR5 desktop upgrades needing 32 GB
The module fits systems that accept DDR5 UDIMM memory and can operate at 5600 MHz JEDEC speeds. It is not for laptops or small-form-factor boards that require SO-DIMM modules. Buyers who need ECC error correction or registered DIMM signalling should look at server-grade memory instead.
Check motherboard DDR5 support
Verify that your desktop motherboard lists DDR5 UDIMM compatibility and the maximum capacity per slot. Confirm the board can run 5600 MHz at 1.1 V without manual voltage changes. Consult the vendor memory QVL to ensure dual-rank 2Rx8 modules are validated for your specific CPU and chipset combination.
Fordele
- 32 GB capacity for demanding desktop workloads
- DDR5 5600 MHz speed for high bandwidth
- CL46 latency tuned for JEDEC standard operation
- 1 V voltage reduces power draw
- 288-pin UDIMM fits standard desktop slots
Specifikationer
Der er endnu ikke offentliggjort specifikationer for denne vare.
Spørgsmål om denne vare
Do I need a motherboard with DDR5 slots to use this 288-pin 5600 MHz module?
Yes, this module requires a motherboard that supports DDR5 memory with 288-pin UDIMM slots and the JEDEC standard 1.1V voltage.
Can I add this dual-rank 32 GB stick alongside my existing DDR5 modules?
It can be installed with other DDR5 UDIMMs, but the system will run all modules at the lowest common speed and the motherboard must support dual-rank 2Rx8 configuration.
How do I confirm the CL46 timing and 5600 MHz speed are active after installation?
Check the memory tab in CPU-Z or enter the BIOS to verify the module reports 5600 MT/s, CL46 latency, and 1.1V operation.
Også på denne hylde
Kunderne har også sammenlignet disse
Samme hylde, samme kasse — otte mønter og 30 minutters kurslås.



